Comments (1)
Add Comment
-
Views: 802
10# foam CNC on a special steel table. This is 1/2 of the mold. I can't show all the details but below are some general photos. -
Views: 723
Mold parts together, leveled, and bonded. Time to fill and prime! -
Views: 872
After filling, primer and a buff. -
Views: 702
First lay up in. -
Views: 756
Some time after ...ready for core. -
Views: 836
Core -
Views: 725
Core bagged -
Views: 820
Last plys going down.
-
Views: 823
I asked Alexis if there was something I can bring from the USA and he asked for Jell-O. I would never guessed. -
Views: 637
This guy ate about 10 bowls while I was there. Seams Jell-O is not in France! -
Views: 868
Some Voltij for F3X. One Nemo is mine the white for a customer. Nemos paint scheme is now available on the Voltij for a little extra cost! -
Views: 934
Alexis working on a Allij stab in the prep room. -
Views: 765
Some of the models we made, Alliaj, 2 Prodij, stab parts for Voltij. A Alliaj and Miraj are already boxed up not in photo. -
Views: 907
Cloth prep area with templates on wall for fuse. -
Views: 869
Micro-epoxy curing in oven for ailerons. -
Views: 812
Oven on top with mold storage below. All homemade.