Cjhana's blog View Details
Posted by Cjhana | Oct 13, 2019 @ 09:49 AM | 3,797 Views
Hi guys and gals
So far everything seems to be working on the software however when I disconnect led and try to startup (in att mode) using one of four csc commands I get a double yellow blink then 3 red blinks and if I continue holding command led blinks green three times only once, then back to yellow and red blinks? Is this normal?
Also I noticed when I was calibrating sticks the elevator bar moved to -1000 but only 987 the other way after calibration would this effect csc commands starting motors? I bypassed MC to make sure my esc were working , when I connected to throttle channel on rx they all worked fine? Please help