-
Views: 151
-
Views: 163
FW Mig21 with East German markings. Callie's graphics! -
Views: 168
FlyFly BAE Hawk in Swiss markings. Callie's graphics! -
Views: 173
FW ME262 with Dynam canopy and full cockpit upgrade, Taiwan Tornado electric brakes, new scale nose leg and CS 70mm fans. -
Views: 156
FlyFly Phantom. Upgrades include alloy legs with wheel brakes, flaps, medium size servoless retracts, CS9012 fan with 1600kv outrunner. Callie's graphics! -
Views: 344
Lander T33 on a rainy day. -
Views: 336
Lander cockpit. -
Views: 396
Lander T-33 90mm with Callie's Graphics
Comments (9)
Add Comment
-
Views: 155
-
Views: 180
Typical EDF test stand made from foam packing material. Simple and quick to fabricate. -
Views: 189
Typical weight addition using duct tape. -
Views: 174
Typical mark on motor shaft. -
Views: 196
Slot cut in adapter for proper tightening capability. Some alignment marks before clocking the fan. Whiteout would have been more visible on the rotor but felt pen can work. -
Views: 190
Outrunner with stiff wire wrapped around the bell and twisted, just before cutting to make the trial weight. -
Views: 169
Here is the twisted wire cut short and a black mark made opposite to the trial weight twists. -
Views: 187
Here you can see outrunner bell with material drilled away after determining what side of the bell was too heavy (using the twisted wire trial weight).