Comments (0)
Add Comment
-
Views: 354
Test fit -
Views: 338
Motor stick placement with mock up motor. -
Views: 310
Motor vectoring cable alignment -
Views: 289
Cable clearance and alignment for front mounted servo -
Views: 341
Motor stick henge and cable set-up check with mock up motor. -
Views: 280
Forward mounted vector servo -
Views: 296
Tight -
Views: 304
Close up
I guess Brad liked the colors of the Glow pwr Wizz so its a repeat.
They do stand out in the air and contraz well.
Its covered, hinged and servo'ed.
Need motor mount hard points, bottom fin, linkages and horns but it's a long weekend
They do stand out in the air and contraz well.
Its covered, hinged and servo'ed.
Need motor mount hard points, bottom fin, linkages and horns but it's a long weekend
Diamond Dust is next on the block.
Drive depends on how E Wizz works out
Drive depends on how E Wizz works out
-
Views: 456
Less the Glow Motor, this is typical of the end product. (Its actually the last one I built in FL) -
Views: 367
(Initial mock up) Mounting plate will be either Aluminum or Carbon Fiber. Oversized at this point, it will be thinned down once all mounting points are set as well as positioned flush with the mounting plate lead edge.
-
Views: 473
Compare adaptors and motor shafts on MEC GB. MR 28mm with MEC adaptor (blue), Neu 1107 and AstroFlight adaptor (Aluminum) -
Views: 343
Checking depth of GB and motor (actually could run this way) -
Views: 359
Another mounting option, motor plate would be notched and assembly set back from this position with prop shaft flush with front of the plate. -
Views: 375
Picture this set-up only inset back approx. 20-25mm -
Views: 332
As far as the mounting goes, its a blank canvas. Outrunner mounting with cut-a-way the most all the plate that ties the LE and Spars into the airframe, but that will be overcome it needed. -
Views: 350
Shaped and ready for flying surfaces and covering, as it sits, 6.2oz/177g
