mudman1959's blog View Details
Archive for April, 2017
Posted by mudman1959 | Apr 16, 2017 @ 05:31 PM | 6,836 Views
I acquired this one from a Friend this last year and decided to start putting it together. It came with a old power system "Brushed Motor" and a Ni-cad battery. Updating it to "Brushless" and a 3 cell Lipo. I need to finish taping the top and bottom of the wing first then it gets covered with a very thin mylar tape which was included in the kit. Going to use a 2700 Kva brushless motor on it turning a 6x4 prop and a 2200 Mah 3 cell lipo. Wingspan is 38 inches so this one should be a real screamer... The original motor mounted onto the preformed plastic center section so that needed to be modified to use the brushless motor. Added a spar to the center as this one will be going a bit faster than the original intended design... Hope it stays together! Stay tuned...

Mudman1959

"Zagi" Fun!!! (2 min 8 sec)
...Continue Reading