I've been flying one thing or another since the late 80's but until your holding this, see it in person, or hear it do a 100+ mph overhead flyby). it's very hard to describe it. The Hildabeast is definitely a different creature. Here's a few photos including a 5" size comparison and screenshot with 108mph maiden run.
After all of the positive feedback with the 10" Hildagard since its introduction in March of this year people have expressed interest for something similar and even bigger so I'd like to introduce the Hildabeast. Stefan van der Ende and myself went back to the drawing board and this was the result after hours of computer design (thank you Stefan) cutting and revising frame parts, getting it built, and finally in the air. Until you hold this, see it in person, hear it do a 100+ mph overhead speed run, or have it hanging in the air during a slow flip it's hard to describe what it can do and how well it does it for a frame of this size. The 570mm Hildabeast frame swinging 14" props is definitely a different creature. I'm proud to announce that as of now the Hildabeast is for sale and the first batch of pre orders is almost sold out already but there's still time to get in. You can contact myself or Stefan if needed. Thank you again to Jubal Spano.
My personal example for the prototype and it's parts List:
Frame Stand-in quad design Hildabeast
Flight Controller Matek F405-CTR Flight Controller
ESCs 4 x Lumenier 51A BLHeli_32 32bit 2-6S w/ Telemetry
Motors 4 x BrotherHobby Tornado 4215 T7 680KV Long Shaft 6-8S Brushless Motors
Propellers 4 x E-PROP 14 X 8 Bore 8mm with 6mm adapters
FPV Camera Foxeer Predator V2 Mini Camera 1000TVL Super WDR FPV OSD 1.8mm NTSC
FPV Transmitter TBS UNIFY PRO 5G8 HV
Antenna TrueRC AXII SMA 5.8 Long
Receiver TBS Crossfire Micro Receiver V2
Ready to Sky GPS
Battery ThunderPower 3300mAh 6S 22.2V Elite 55C LiPo Battery
About charles hidalgo
