I have swapped the stock RX out of my wifes and my Axe CPV3 and wanted to post the transmitter settings I use on our CPV3s. Actually, we have replaced the stock HeliMax 3in1s as well on most of our helis and my favorite configuration is:
Eflite EFLH1032 2in1 ESC/Mixer
Eflight G110 HH Gyro (really a rebranded Telebee but I like using the Eflite just because )
AR6100 RX, these are going away and I really like the AR6110, if you mount it in the front of the heli I think the standard is better, using the AR6100E I mount it in the rear of the heli.


The only difference between using the stock 3in1 and the seperate 2in1 and gyro is in the gyro menu, otherwise, all other menu entires are the same. Be careful, you may need to change signs on the swash mix and check your servos for proper operation. The good news is, if the servos are reversed, you don't have to go into the servo and reverse the wires, just swap them in the menu

These settings also work in the DX7, it just has different menu names. Most everything just transfers over (except the Gryo stuff is a bit different).

Anyway, here are the settings Merilee and I use in our transmitters:


DX6i Settings for Axe CPV3.
ADJUST LIST

D/R and EXPO Menu
AILE +5% expo
ELEV +5% expo
RUDD INH

GYRO Menu
INH

(If you are using a 2in1 and separate gyro this is the only change required:
RATE SW-GYRO (uses FLAP/Gyro to switch modes on DX6i)
0: 99% (this value is set during flight testing,...Continue Reading