Comments (0)
-
Views: 571
morning light. this ia what was seen from the living room, prior to mandatory evacuation of our community. -
Views: 404
this was 10 minutes later, loading up the car with Silvia and Rico. -
Views: 405
As the sun started to rise, the Helos began the water drops, one FD pumper on scene at this point in out 130 home community. -
Views: 369
dark smoke is the first of many home to go. -
Views: 376
at sun set, the house was fine, so I went to our property about a mile north in the mtns. This is a Cat 824, getting ready for a new task -
Views: 378
The fire fighters on this ridge had shovels, and welcomed the 824's big blade support. -
Views: 409
the guys to my right here are "Hot Shots" from Kern County. They saved my land and tousands of acres in the forest. standing at the "divide", as seen later. -
Views: 384
This is one of the tools that the Hot Shots use, its a magnesium flare shot from a pistol, good fun starting fires (fighting fire with fire). They understand Fire Science!
-
Views: 517
view to the North East from the lower plateau. despite being very isolated, this is just 20 min north of Burbank. -
Views: 391
view to the west from the upper plateau. The top is where we can slope. from that peak, the slope drops into the San Fernando Valley from a 2500 foot elevation. -
Views: 397
tuning up the landing zone, good slope soaring here with a 2500 slope face into the prevailing wind. backside landings on the upper plateau as needed -
Views: 415
bringing in the temporary "hanger"
-
Views: 733
the basic idea -
Views: 488
all the goods and a zip tie to make a simple spacer for the cut cone / cooling. A PQ 2S 1500 lipoly batt is under the ESC. -
Views: 451
low power up to 150 watts, the tape was sufficient as a motor mount. Motor shown here is a 2 to 3S Axi Mini Extreme with integrated planetary geardrive; it kicks but on 3s with LMR throttle use. And with extra cells velcro-ed to the top of the wing, if yo -
Views: 452
modified cone. The velcro on the top allows for an additional batt (zagi style). This bumped up the power to 500 watts. I noticed no drag penalty, although I am sure there was a little bit. Makes for happy lipos if they are being pushed; lots of cooling : -
Views: 511
RTF. with this particular motor, a geared Mega 1615/4 with gearbox on 4S, 3 oz tail weight temporarilly added to the fuse for balance; she really penetrates this way and I liked this AUW best.
Sticky:
Carbon Bannana data
-
Views: 579
This modified nose cone shows how the drivetrain fits onto the slope fuse. -
Views: 427
-
Views: 444
-
Views: 424
She's only been flown on grass. Can you tell? :-) -
Views: 417
-
Views: 429
This is the modified slope fuse. The front 1/4 inch has been removed. I use Gorilla tape to secure the removable motor and cone assembly. -
Views: 397
Dr. Jekle -
Views: 428
Mr Hyde
