Comments (0)
Add Comment
Sticky:
Just to see
-
Views: 217
The palms and the arm were made from an old plumbing regulator. -
Views: 185
The shank was made from an old Price Pfister tub/shower stem. -
Views: 180
Pressed the palms into slots of the arm base, silver soldered them together. -
Views: 169
Needs more patina. -
Views: 189
The ring at the top of the shank was filed, and ground to shape, as was the rest. Including the pin holding the ring to the shank.
-
Views: 210
Inside view, of Puffers lifeboat (punt) it measures just over 10 inches. -
Views: 202
Hull was first carved out of "Smooth set 20" then poured silicon rtv over this. mixed up another batch of ss20. poured on top of silicon, and plug. -
Views: 196
Pulled plug out, brushed in gel coat. let cured. brushed in epoxy resin, laid in fiberglass. let cured. -
Views: 178
Cut pieces of old redwood latice. Made interior of punt. Painted exterior.
-
Views: 259
At just 2 sticks long, and just a few ounces it handles well. It uses a large servo motor, servo speed control and 4 AAA cells. -
Views: 217
The roof was made with fine sand paper, painted to look like roofing material. Life rings made with balsa and masking tape. cabin from Evergreen sheets of plastic. -
Views: 227
Lots of strips of plastic cut and glued. -
Views: 231
Birds, and skipper sculpted from plastic model car sprue, using hot soldering iron, and small files. -
Views: 252
-
Views: 216
