Hello everyone,
Well i had some motors that did not work properly or were bad, so i ateempted to rewind one. first i reused the wire just to see if the motor would run, and it did, yippe
. So i stripped it and found a little spool of wire in the garage so i winded another one with new wire, and it worked too
.
so this is the motor in the pic, i am going to start winding motors and eventually get better at it, and yes it gives a big advantage in rc flying.
I did not read anything to get started, just watched my friend Alex wind one, and with a few helpful tips, i was able to wing one on my own.
If anybody has a blown outrunner that they dont need, PM me, i can use it.
Please tell me how i'm doing, good
or bad
so i have something to keep in mind while i'm moving on, you can use the poll above
.
Thanks for looking!