-
Views: 283
Made three of them actually, new one for me and two for some friends that wanted to film their flying antics! -
Views: 285
Mocked up the platform with cardboard stiffened with CA -
Views: 283
Impregnating fiberglass with gorilla glue (much nicer to use than resins, although it needs to dry overnight to get really stiff). -
Views: 251
Wetting out and squeegee with piece of foam board -
Views: 262
Set four layers of glass onto the cardboard forms. the cardboard sets the angles for the feet/tabs that the standoffs will bolt to. -
Views: 286
pulled part, now getting epoxy stick/mighty-putty squished around the mount... this make a mount where the camera can only be in one position. -
Views: 266
-
Views: 298
Test fit with standoffs after drilling holes through hat.
Comments (3)
Add Comment
-
Views: 481
shunt switch is actually smaller on the outside than most trusted switches for giant scale. here it is on the SHB: (vibration from both single cylinder gasser and the rotor) -
Views: 299
powerpole shunt, much more ugliness sticking out of plane when armed. -
Views: 282
"ArmSafe" switch. -
Views: 309
more ArmSafe, recessed nicely, not much sticking out... it's also obvious it's armed. -
Views: 372
fancy metal shunt switch/mount of deans plug from SpotOnRC
Sticky:
The Maelstrom
Sticky: