Comments (0)
Add Comment
-
Views: 206
Top, fluorescent tape applied to Mobius cameras. Note one has a lanyard to tie a string on. -
Views: 201
bottomside -
Views: 204
ends where the card is -
Views: 200
lens side -
Views: 180
swivel -
Views: 208
tether mount, swivel, and nylon string -
Views: 198
String looped around wire. -
Views: 225
Here is the mount CA'd in the wing, with the string attached. I use a loop, so I can remove it, if the camera is not needed.
-
Views: 217
Suspended -
Views: 214
suspended -
Views: 227
back shot -
Views: 239
here's the L bracket screw to the truss, and the para cord ran through the holes -
Views: 218
Same for the Valiant hanger-screwed to the truss -
Views: 207
both -
Views: 216
tethered the tails together and to the wall to keep from moving, and bumping into each other -
Views: 232
both hanging up with 7 feet below the lowest point
-
Views: 219
here's the cock pit, and you see the black Velcro for Mobius camera placement -
Views: 196
long wingspan -
Views: 209
bottomside -
Views: 207
I used some reinforced tape up front to keep from damaging the foam -
Views: 218
Here the TM1000 antenna sticks out the side of the fuse -
Views: 235
the Lemon 10ch. receiver antenna is out the other side, also remote is located inside up front. I like the 10ch. receiver. -
Views: 217
You see the yellow string is attached to the wing joiner plug
Sticky:
Assassin wing--HOTROD-
-
Views: 242
Look what the mail man dropped today!! -
Views: 232
Look -
Views: 260
Here -
Views: 242
at 18 in rule -
Views: 246
the goodies -
Views: 252
What it will look like. No winglets are on this one. Got to find some of that dang extreme tape. Bottom is UV shield/ clear covering to protect the foam. -
Views: 216
hot glued together -
Views: 241
spar installed Don't use permanent marker for drawing it don't come off after glued in
Sticky:
188 AG Wagon
-
Views: 247
Got my N numbers on. -
Views: 233
repainted it. -
Views: 301
side view of freshly painted plane. I am going to add some stripes to it. -
Views: 272
from the back -
Views: 230
made the cooling vents functional -
Views: 271
bottom side -
Views: 271
-
Views: 268
Had to replace a bad servo from factory. I reversed it in my radio to function the right way.