Posted by MADRCER | Today @ 12:24 AM | 1 Views
True for True this is the World's Fastest 6s TFL Pursuit as of 11/16/18 (with no edits or cuts in the video). The boat got 79mph by the data logger and 78mph by the GPS device. The prop was prepped by Chris Hoffmann (dasboata). The first" teaser pass" leading into the start of the video was my run right before this one and the max speed from the data logger on that run was 78mph and the gps was 77.2mph.

World's Fastest 6s TFL Pursuit (79mph)!!! 11/16/18 (5 min 12 sec)

Posted by old4570 | Today @ 12:08 AM | 4 Views
Mail call !
I kidd you not , my order of control horns arrived Sunday Morning
So I had no choice , it was time to make some moves on the Ripit .
Ground some holes in the carbon boom , installed some control horns and made up some control rods .

Everything seems to be working fine ..

Two things need doing , some sort of nose cone / pod and attaching the wing .
I guess I dont desperately need a nose cone ?
Still , will give it a go .
Posted by JureZ | Yesterday @ 11:13 PM | 27 Views
here is a video, after switching to a 10g brushless motor (custom rewound, Y , 36 Turns per tooth, Kv= 635 ) ,
10 A ESC,
Battery 2S 300 mAh 30C,
APC 7*3.8 SF Propeller ,
FrSky 4 Channel RX.
two UMX Spectrum Linear Servos ,
82g AUW, wing loading = 3.16 oz/sq ft ,
Static test current draw at full throttle : 2.2A @ 8V , 17.6W into the ESC.

Flying outdoors, note the smoke from the "Camp Fire"
micro nutball - 10 g brushless motor - new propeller - Movie (3 min 0 sec)

Posted by rclad | Yesterday @ 10:30 PM | 51 Views
I've flown the 2019 Intermediate sequence many times now, and one thing that leaps out for me is that this class requires a lot more practice than Sportsman - and every day - to get decent at it!

I haven't been flying much since Regionals in mid-September - just once or twice on the weekends - so my last flight this past Sunday wasn't very good. But I mounted a Mobius I camera in the cockpit in place of the pilot figure to see the view of the sequence from the plane. This ain't precision flying, but it's a lot of fun to watch from the pilot's point of view. The airfield is Flying Cardinals in Hebron, KY. They have a geotex runway. I used Dashware to add the telemetry data. I forgot to turn logging on for the variometer, so no altimeter! This sequence typically takes me to about 900 feet AGL.

There was a direct cross wind (about 5 mph on the runway and stronger above), and temperature was 42 F.

In the first sequence I forgot the 2 point roll at the top of figure 4. and then had to break sequence as I approached the top of the cross box Humpty when I heard a POP! I thought the ESC blew. Once I realized everything was good to go I resumed the sequence - kinda sorta - with the next figure. (It is supposed to be an inverted entry to the P-Loop, then a half roll on the upline.)

A rear view camera would help to see the rolls on the upline when there are no clouds in the sky. I'll have to add that next time.

The camera really helps me see all the mistakes I'...Continue Reading
Posted by TMac54 | Yesterday @ 08:28 PM | 71 Views
Finally! Got to do the Maiden Flight video on our Micro FPV 2.5 Inch Build!
Meet “Lexi!” Our FlexRC Ascent 2.5-inch build, with on-board Runcam DVR, as she sets sail on her maiden flight. She’s sportin’ the Orange and Green pinstripes.
Maiden Flight was a “Blast!” Check it out below. It’s a Jolly (Roger) Good Time, Savvy? Yo-Ho! How many different “Pirate” things did you see in this video? What did you think about the Onboard Runcam DVR video quality?
Micro FPV 2.5 Inch Drone Build - FlexRC Ascent Maiden Flight (4 min 28 sec)

Posted by SteveC68 | Yesterday @ 05:18 PM | 157 Views
Here are the pics
Posted by decuzar | Yesterday @ 04:34 PM | 157 Views
3dhs 108" extra 330lt


Specifications:
Wingspan: 108"
Length (with spinner): 100" with rudder installed, 90" without rudder
Wing area: 2180 sq. in.
Weight (RTF): 23-28 lbs.

Posted by bentkarnes | Yesterday @ 04:11 PM | 170 Views
Ok first of all......I’m new to Drones.......I know I know.....damn rookies. Day 3 I smacked a tree dead center even though I had changed direction and reversed but it didn’t respond. Maybe it was me. Anyway she won’t fly anymore and displays a message of “ Defective barometer sensor alert” in the app. I can turn it on and off but will not take off or even connect wirelessly anymore. I’m new and clearly cheap but I was really enjoying this. Help me get her back in the air please!
Posted by GBLynden | Yesterday @ 03:09 PM | 177 Views
I am pleased to announce the GBLynden's RC has reached 20,000 subscribers! As a result, we are going to give away some RC Stuff.

These are the giveaway items:
- CrewZinn Flight Deck RC Work & CG STAND (Continental US Only): https://goo.gl/9eLHVK
- Mini AR Wing (Open To Everyone): https://goo.gl/E69zjZ
Or
- ZOHD Dart: http://bit.ly/2Jra4Og

Simply leave a comment on video's YouTube page mentioning your favorite GBLynden's RC Video and the Country you live in to enter to win.

GBLynden's RC 20,000 Subscriber RC Giveaway! (4 min 14 sec)

Message me here or on my GBLynden's RC Facebook page with any questions!

GB
Posted by Maksimuzz | Yesterday @ 02:09 PM | 219 Views
7.4 15.07.2017

I had return to work on the autopilot by 2016 only. I decided to finish the job and install the GPS. So, when GPS processing was written, it was necessary to check everything. Now I want to introduce my Dusty. The layout is made on the basis of the Dusty toy. The ailerons and rudder were already moving,

Name: DYSTY.jpg
Views: 1
Size: 898.4 KB
Description: Layout of airplane

I had to cut only the elevator. In the layout 3 micro-servos and one ESC are installed. What is it for? To debug the work of the controls, I did control races on the car and walks with the layout, to test the flight algorithms using GPS. It is very difficult to understand if everything works correctly, and the layout immediately shows how exactly the steering gears work out and how the planes of the aircraft move. Also recorded a short video demonstrating the work of Dusty. After debugging on the layout, the autopilot was installed on the aircraft. In the test dates directory, you can also find a log of the journey on the Dvinskaya-Scottish-Nevelskaya route, and the route from the Michurinskoe-Dvinskaya. The latter contains 25 waypoints, and this route was passed correctly, which showed quite an acceptable system for deciding whether to reach the next waypoint.

7.5 09.08.2017

It was the first flight of the "Dragon" with the GPS module, 5 years after the first flight. The battery was the same. A fragment of the flight can be viewed on the video. On this day there was a strong south wind about 20-30 km / h. The approximate flight...Continue Reading
Posted by Ken Lapointe | Yesterday @ 11:27 AM | 276 Views
Just completed the Parkfler Plastics OV-10 Bronco

2 Eflite Park Flier 450 motors. Weight is 3lbs 2 oz without battery
Posted by John75 | Yesterday @ 10:42 AM | 273 Views
I'm new to the hobby and have got myself a Feiyue 06 for starters. Was running great until the second run when I lost a wheel nut, hex hub and pin and a small Hexagonal T head screw (4.0 x 10TM) from the front axle! Waited 2 weeks+ for replacements on eBay and ran today to find that the 6 wheel drive is no longer functioning. At first I thought it was all back 4 wheels operating well, but but now I've realised it's only the middle two wheels that are powered. Any ideas as a complete beginner on how to go about fixing it? Should I open all up and see if a drive shaft has come out or take it to the store (an hour away and when I get the chance!)? If I only up do I go from the top or the bottom? I know how to get the shell off at least!

Any advice much appreciated!
Posted by Alphonso | Yesterday @ 09:07 AM | 321 Views
Here' another Yak taking off from grass in less than 5m just to show how well it copes. If you dont try, it will take off by itself a few meters later.

Fms yak 130 6s JP fan (4 min 12 sec)

Posted by Alphonso | Yesterday @ 08:28 AM | 341 Views
This was a maiden with a Freewing Yak130 that a friend filmed. I had no idea if it could cope with grass back then hence the hand launch. Darn thing nearly tore his arm off with that JP fan and HV lipos. Turn up the volume and tell me what you think.

Yak 130 6s JP fan (0 min 41 sec)

Posted by aopen3434 | Yesterday @ 07:04 AM | 369 Views
Vertical take off and landing Air plane gas Electric hiybread can be used for GAS & OIL Exploration, pipe line monitoring, ship to ship transport. Reconnaissance and security long flight time up to 6 -8 hours 10kg payload. imaging gimbal packages sold apart, demo flight & Air frame Assembly video of VOLT kit.

CW-20 VTOL Hybrid UAV Introduction Demo

CW-20 VTOL Hybrid UAV Introduction Demo (2 min 32 sec)




GLADIUS SUBMERSIBLE UNDERWATER FPV DRONE Advanced Pro http://brushlessgimbal.ca
Gladius Submersible Drone Official Procut Video (2 min 8 sec)
...Continue Reading
Posted by davidmc36 | Yesterday @ 06:57 AM | 378 Views
There is a nice little boat hiding under there still.

Found a complete drive, 3:1. Would like to have a 2:1 also. Can't seem to find just gears.

Might go retro if the Speed Control is still viable. Worked well when new.

This guy made a beauty retro:

https://www.tamiyaclub.com/showroom_...106509&id=3226
Posted by Tazkiller85 | Yesterday @ 05:59 AM | 395 Views
Yep Les Amis,
Opération MULTITESTS !!! Voici une petite revue un peu différente de mes habitudes, profitant d'une journée ensoleillée j'ai décidé de vous montrer 3 produits en action ... La Hawkeye Firefly Fortress, que je vous avais présenter récemment, la Caddx Turtle V2, dont je vous avais parlé et que j'ai décidé de monter sur le Emax Hawk 5 et enfin la Stack (pas chère) MAMBA F405 de chez Diatone, dont je me suis servi pour refaire complètement le "fameux" DarkMax. Et bien je suis plutôt satisfait des résultats obtenus mais je vous laisse juger par vous même des qualités et défauts de ces produits. Je précise que je n'ai en aucun cas, retouché les images des 2 caméras, tout est brut de pomme ! lol ... Bon Film à Tous .


HAWK5 et DARKMAMBA !!! Caddx Turtle V2, Firefly Fortress et Mamba F405 ... (33 min 17 sec)


MULTITESTS !!!

Les produits présentés sont visibles ici (en cliquant sur ces liens vous soutenez ma chaîne) Merci à vous :

COUPONS BANGGOOD : 2018BF8% (Black Friday) ou PICODICOM
- Firefly Fortress : https://goo.gl/cVE5XB
- Stack Mamba F405 : https://goo.gl/zSNjsj
- Stack Mamba F405 MINI : https://goo.gl/anh1Gn
- Caddx Turtle V2 : https://goo.gl/JZFDYV
- Vifly Finder : https://goo.gl/wwK1yT
- Récepteur FLI14+ : https://goo.gl/bmBdXM
- Protections Plexis : https://goo.gl/y52yLv
- Sangles Kevlar RJXHobby : https://goo.gl/qPt3WU
- PROMOS BANGGOOD BLACK FRIDAY : https://goo.gl/eSUxF8

Mon matériel :
- Caméra GIT2P (...Continue Reading