-
Views: 336
aluminum rods for support for both wing halves. There are carbon tubes in each wing half these pass into. -
Views: 258
Marked and initial drill location for wing bolts. This is a self mod and not in the manual -
Views: 261
Pencil through the drilled hole to mark on the plywood where the blind nuts will be placed -
Views: 245
This is the plywood i put on each wing half for the blind nuts -
Views: 275
-
Views: 268
Here you see the wing half bolted in place. This was before gluing the wood plate on the bottom of the plane itself. The wood has since been painted silver to match the plane's bottom.
Comments (3)
Add Comment