There are so many questions cropping up about what settings people are using with the above combo for various helis that it's getting difficult to find the info, even using the thread search machine.
Since HiSky's resident pilot Alan set mine up to work as close to perfectly as it comes with my HCP100, I thought I'd start posting the info on my blog to make it easier for folks to find. Also means if I lose my own settings for any particular reason, they're easy for ME to find again
.
As and when I dig up the info for other helis I will post it here too. Meantime the settings below will be a good starting point for anyone wanting to use the TH9X and T6 with the HCP100/V922 helis.
Please note, unless indicated otherwise, the settings listed are for the TH9X running STOCK firmware. If anyone has other settings which work well, please feel free to post them up here too. If anyone wants to post up settings with other firmware - ER9X, OpenTX, etc - don't be shy. Depending on whether enough info comes in to start getting confusing I can always open fresh threads for the alternative SW and shove the entries around to suit.
Happy flying guys,
Fin.
Settings for HiSky HCP100/WL Toys V922
Set WL-T6 to Futaba mode - 2x green lights.
Type select: HELI / HELI3-1 (120° swash)
Reversed - rudder
Important update:
With the Flysky TH9X (don't know about the Turnigy and others) when you change the model type (plane, heli1, etc) it asks "reverse throttle?". I found out recently that if you hit menu it means yes and exit means no, so remember and take your blades off before you bind the first time in case it goes straight to full throttle
TH curve:
normal 0-48-78-94-100%
ID1 100-90-85-90-100%
ID2 flat 100%
PITCH curve:
normal 25-37-50-75-100%
ID1 & ID2 linear 0-100%
Endpoints:
ail, ele, thr, pit 65%
rud 90%
all others 100%
swash mix:
pit 60
ail
-40
ele 40
D/R & expo:
switch off - all 100, expo 25
switch on - all 100, expo 0