-
Views: 258
Bare kit with Derek's blunt -
Views: 255
Great fit -
Views: 263
Modified stock mount, epoxied a stryker mount in it -
Views: 252
Shortcuts Krylon touchup -
Views: 262
Starting the channels and twisted wires -
Views: 259
components layed out -
Views: 268
getting there -
Views: 288
Prixim camera in place
-
Views: 508
My breadboard LOL -
Views: 446
In the beginning, a few turns on the 1k potentiometer and osd appears -
Views: 490
Moving the lines around to suit my needs -
Views: 438
Test completed Aiptek 720P HD Camera -
Views: 479
Finished assembled project, left conector is current sensor and main power, right upper connector is both loader and gps connection, lower right is video and gnd -
Views: 475
Able to take it apart, take the arduino inside for any reprogramming and theres still a little room left inside for more stuff
-
Views: 529
RF and Trainer port reboard removed -
Views: 445
Flytron LRS Rx or Tx -
Views: 475
RF deck testing -
Views: 486
Removed RF deck and mounted LRS in its place, sma connector in original antenna hole -
Views: 452
Crystal hole is now (top pins) PC Connection (botom pins) Bind plug Servo Ext is TrackR2 connection Headtracker -
Views: 382
-
Views: 388
-
Views: 496
Dual Patches trimmed to 1280, BOB Rx'ers, RV Diversity, Calibration and manual switch for RV Diversity, with LV Audio alarm at 10.6V -
Views: 402
Backside board, BOB Rx and 4000mah lipo -
Views: 417
-
Views: 414
-
Views: 433
My version of IBCrazy's diversity controller, worked fine, but now have the RV Micro Diversity w/calibration -
Views: 452
-
Views: 489
Bare Bones approx. 20" motor space -
Views: 418
HD Camera placement -
Views: 365
Maiden flight ready -
Views: 388
HD camera installed -
Views: 413
Full A/V Tx -
Views: 338
We have Light -
Views: 219
Fully loaded, Multi Wii FC, 1280 VTX, Aiptek 720P camera, GLB motors, DIY OSD, GPS, and Chainlink LRS -
Views: 232
New quad being built
-
Views: 473
Maiden flight time -
Views: 386
Stock canopy fitting -
Views: 383
Unprotected HD camera , after landing and flipping over. Decided to protect it a little, this pic is from EZAX (may she RIP) -
Views: 378
Alternate pod with P&T -
Views: 381
Protected HD Camera with new changeable lens -
Views: 400
Extreme lightend HD camera -
Views: 328
12/10/10 -
Views: 342
12/10/10
Sticky:
Trimersion goggle mods
-
Views: 597
The start of component placement. Wing is a JetSet Viper originally a brushed twin -
Views: 472
Homemade pan and tilt -
Views: 477
wings epoxied on servo cutouts -
Views: 473
Checking CG requirements -
Views: 506
-
Views: 441
All leads handmade, along with homemade L/C Filter -
Views: 434
Let the spackling begin -
Views: 440
Monokote applied