steve wenban's blog View Details
Archive for December, 2009
Posted by steve wenban | Dec 06, 2009 @ 02:35 PM | 5,631 Views
Went out for a fly yesterday , first cab off the rank was to try the new Bitsa out so just a small toss to see if I'd got the CG right well blow me down that small toss continued out off the hill and turned into a great flight no trim change of CG adjustments needed at all, its a fun little flyer worth the couple of hours it took to put it together . sorry no pic's forgot the camera
oh well back to work.
Posted by steve wenban | Dec 04, 2009 @ 03:58 AM | 5,736 Views
I was only going to do the foward cockpit with detail and just half detail the rear ,but it got the better of me and I started to deck out both . So far it does'nt look to bad .
Posted by steve wenban | Dec 01, 2009 @ 02:21 PM | 5,405 Views
Last weekend My son went "I'll clean up the workshop dad" you Bewdy says I anyway long story short he found a set of foam cores I had cut for someone that never picked them up I think from memory they where MG06 and very high aspect ,but I thought what the hell I'll just make up a pod fuse shove some gear into it and chuck it just for a giggle .On Monday I had it pretty much done and last night fuse and wing where joined . the only thing remaining is the final tape job all this for a few hours mucking about
I introduce the BITSA.