-
Views: 190
Thankfully, I found out early on that the black paint on the fuse was not adhering well to the foam. This prompted me to strip the entire fuse before my first cote of Tamiya. -
Views: 205
Lucky I had some help for the job at hand. -
Views: 198
You can see here how easily this weird rubbery textured black paint comes off. -
Views: 187
Here the fuse is pretty much all stripped and ready for the new paint. -
Views: 197
Ready to mask the glazing and wash with dish soap. -
Views: 197
Shipping damage is easily fixed. -
Views: 234
More shipping rash, little spackle goes a long way. -
Views: 219
This one was a bit annoying, cause it's right on top of the fuse. It's a very noticeable area.
Comments (0)
Add Comment
-
Views: 231
I forgot to add this picture. It shows the two flashing white ones on each wing tip at the back corners. And the center one on the Rudder is solid white. -
Views: 220
Rcbyair bringing her home -
Views: 223
extremely visible in the air -
Views: 209
Paint Color is Yellow Krylon Fusion for Plastics -
Views: 221
leading Corner is Green LED and Rear LED is Flashing White -
Views: 186
Two Landing Lights -
Views: 213
Right LED is Red Beacon, Left LED is solid white -
Views: 216
Did a little detail work on the pilot
-
Views: 192
Removing the engine mount reveals a previous bad installation of a replacement motor mount over a year earlier. -
Views: 190
We can see that the insulation on the red positive wire was wearing away a little bit more every flight. -
Views: 195
It was only a matter of time before I had a major failure to all electronic components of this Trojan. -
Views: 171
Now I will check all my airplanes for this type of wear to the insulation of the wires. -
Views: 165
Here we can see the stress cracks from previous prop strikes and other bad landings. -
Views: 175
More stress cracks -
Views: 176
You can see the Black Collar that holds the prop shaft in place. I believe that when I replaced the motor mount in the past, I made the mistake of ignoring the wire positions during my installation. My mistake not Parkzone's. -
Views: 157
I'm amazed that this did not already cause a major crash.
-
Views: 277
1) All the parts bought individualy -
Views: 226
2) Aileron and Flap Cuts - Servos Cut In - Spar Installed - Lights and Wiring Installed -
Views: 244
3) Servo Cuts Nice and Tight -
Views: 219
4) Wires Converge to Center Inside Wing -
Views: 237
5) Gotta Butcher Everything to Make it Nice -
Views: 236
6) Surgery on New Wing -
Views: 236
7) Nice Straight Lines -
Views: 238
8) LEDs Not Installed Scale, They are Installed for Actual Night Flying on the Water