Posted by Justwingit | Today @ 05:09 PM | 178 Views
Larry Staples' gorgeous BUSA Nieuport 17 flying at the SoCal Scale Squadron's Warbirds and Classics event a while back...
Balsa USA 1:3 Scale Nieuport 17 - FRIDAY FLASHBACK! SoCal Scale Squadron Warbirds and Classics, 2018 (6 min 47 sec)

Frank Kelley was stirring the sticks during this flight and did a fine job !

Posted by GroundControlRC | Today @ 01:29 PM | 375 Views

Eachine Mini F4U Corsair RTF Warbird with Gyro - Review Part 3

Eachine Mini F4U Corsair

Eachine Mini T-28 Trojan

Eachine Mini Mustang P51D

Volantex Sport Cub 500

Banggood GCRC

Here is a link to the Video:

This is another Great Micro Warbird from Eachine and well worth the money in my opinion.
It is a bit Nose Heavy out of the box but .75g of Tail Weight and it balances perfectly.
I think this Plane is a bit faster than the P51D and not quite as stable due to the Gull Wings.
It has a very Wide Flight Envelope but flying too slow will cause a Wing to Dip.
I like the weight of the 1S 360mah LIPO rather than the 1S 400mah LIPO in this Plane.
I need a bit more Elevator and Rudder Movement so I'll adjust the Linkage and Test it out again.
Part 4 of this Review will be Testing the Adjustments and then I'll state my Conclusion on this Warbird ;-)

Here is a link to the Playlist for the Eachine Mini F4U Corsair:

Here is a link to the Playlist for the Volantex Sport cub 500:

Here is a link to the Playlist for the Eachine Mini P51D Mustang: Reading
Posted by vulturetec | Today @ 10:31 AM | 962 Views
This Horus X10/OpenTX widget is based on my Taranis flight-time logger, written to work under OpenTX 2.3.9 on the FrSky Horus X10/X10s as a full-size widget.

The widget keeps track of the number of flights and flight time on individual models. The logging data is stored in GVARs and therefore will remain intact as long as the GVARs 8 & 9 (on all flight modes) are not changed. The logger data can be backed up along with the model setup using companion.

When used with a variometer flights are automatically counted when the aircraft is above a specified height above the ground for specified length of time. The flight ends and the flight time calculated when the aircraft drops below that same height for another specified length of time. Alternatively a toggle switch can be used to manually start and stop flights (ie: a toggle used for normal flight-timers).

  • Originally written for use with OpenTX 2.3.9 on a FrSky Horus X10/X10s - it may work on other platforms but has not been tested.
  • v1.x is intended to be used only as a full-size widget with trims visible, running it in a smaller window may not work.
  • For fully automatic operation the script relies on telemetry data from a variometer (VARI-N, VARI-H, or G-RX6, G-RX8, etc) with the sensor's altitude reset before takeoff. In some situations the sensor calibration may cause it to immediately show very high readings at power-up, if that happens the telemetry should be reset immediately or false flight
...Continue Reading
Posted by Thomas B. | Today @ 07:06 AM | 1,227 Views
We tried Stol Drag Racing with our small Depron Bushplanes. Great fun!
Stol Drag with RC planes (3 min 9 sec)

Posted by Tazkiller85 | Today @ 04:59 AM | 1,372 Views
Yep Les Amis,
Un essai pas encore transformé ! Je vous parle aujourd'hui des lunettes FPV Oled de chez XFLIP, les XFLIP MODULAR, que j'ai en test depuis 15 jours environs. Pour faire court, car je vous explique tout dans la vidéo, ces lunettes et sa technologie sont prometteuses... Le rendu et le confort sont au rendez vous mais j'ai relevé quelques points négatifs, qui, en attendant d'être résolus, mettent un frein sérieux au fait que je puisse vous les recommander ! Si XFLIP est à l'écoute, on aura certainement quelque chose de très intéressant dans un avenir proche. Je vous tiendrai informés des évolutions bien sur... Bon Film et merci à tous pour votre soutien .

XFLIP MODULAR Lunettes FPV Oled - Review Test Démo - Va falloir faire un effort ! (26 min 40 sec)

NOTATAZ : 13/20 Trop tôt selon moi !!!
Plus : Belle image (Oled), Bon FOV de 42°, Ergonomie et accès bien pensés, Précommande à 249€ !
DVR 1280X720, Double baie diversity .
Moins : Alimentation spéciale, Plastiques un peu cheap, Modules difficilement adaptables, Pas d'options dispo (batterie, mousses, faceplate, câble convertisseur, caches modules ), Menus simplistes (peu d'options).

- X-Flip Modular (Précommande 245€) :
- Batterie 8.07V XFLIP :
Mes lunettes préférées :
- EV300D ( Promo 250€ ) :
- Skyzone Oled ( 350€ coupon BGSKY03OU ) :
- EV200D ( Vente Flash EU 233€ ) : Reading
Posted by Dynam RC Detrum | Today @ 04:23 AM | 1,435 Views
Gavin 6C Programming Tutorial (38 min 41 sec)

GAVIN-6C is a 2.4GHz 6-channel transmitter applicable for airplane, helicopter and multi-copter. Using low power devices leads to longer battery life. Support four stick modes to meet different operating habits. Support Trainer and Fail Safe functions which provide security for users. GAVIN-6C could provide the USB upgrade function and be used to set the programmable item of the flight controller for airplane.

MSR66A is a mini 6-channel 2.4GHz receiver integrated with 6-axis gyro and suitable for normal wing, fly-wing, and V-tail airplanes. It provides four different flight modes: Gyro off, Normal, Aerobatic, and Auto-Recovery (Auto Balance) and can be programmable from the matched transmitter.

All using the DSSS&FHSS dual spread spectrum technology, will enhance the transmitter by increasing the anti-interference performance and transmission distance, even can controlled normally in city center, do not worry about the strong interference from high voltage lines, signal towers, city WiFi, etc.

Don't worry wind weather , receiver ABS system keep your flying safe!
Posted by GBLynden | Yesterday @ 05:29 PM | 2,266 Views
This is a windy day flight video with Wild Bill Flynn's E-flite Twin Otter 1.2m BNF Basic!

He did a great job of testing the landing gear at the end lol

Windy Day Flight With Wild Bill Flynn's E-flite Twin Otter 1.2m BNF Basic (5 min 48 sec)

Posted by jmxp69 | Yesterday @ 05:27 PM | 2,253 Views
Maidened the Red Eagle Hummer today.
Red Eagle Model Hummer 3D EPP RC Plane Maiden Flight (12 min 33 sec)

Posted by sonruptl | Yesterday @ 04:16 PM | 2,313 Views
Not too sure if this is where I notify any and everyone that I am looking for a Great Planes Giant 82 inch wing span Super Sportster, or any part of it. fuselage, landing gear, rudder, elevator etc. I would like to find one new in the box but like I say I will take just a fuselage or any part of it....

Great Planes does not make this airplane any more. I am kind of new to the procedures on RC and reading the side panel really doesn't explain it any better as well..... Thanks to all that can help me . email is [email protected]
Posted by Mandy Chen | Yesterday @ 07:04 AM | 2,859 Views
Are you looking for 1304 motor?

BrotherHobby VY 1304 motor:

6250KV: 3S 3inch
7500KV: 2S 3inch
Posted by scousethief | Yesterday @ 06:47 AM | 2,871 Views RTF KIT

Looks very similar to the ZOHD Drift........ Hmmmmmmm .

Eachine new glider (1 min 43 sec)


Brand Name: Eachine

Item Name: Razor

Material: High Quality EPO

Wingspan: 1200mm

Length: 817mm

Version: KIT, PNP, FPV (optional)


Motor: 1806-1800KV

ESC: 30A w/5V 2A BEC

Servos: 4.3g*2pcs, 8g*1pc

Propeller: 8x6 Folding Prop

Flight Controller: Eachine Safe-FC with GPS

FPV Camera: Eachine AIO 400mw Camera with Vtx


- World's 1st RTF FPV Glider, including everything for FPV flying (RTF Version, Click Here).

- High quality EPO material, built-in CF spar for enhancement, crash resistant.

- Auto-launch mode for super easy hand launch and slow fly, agile and accurate control.

- With 6-axis high sensitivity Gyro, fly super stable and easy.

- Built-in high precision GPS, auto return home incase lost control, or press the RTH switch, it will fly back and hovering above the take off point.

- The Eachine Safe-FC can be turn off to reach manual mode, for those professional pilots.

- Detachable main wing and tail boom, glue-free assembly, portable for outdoor flying.

- Optional FPV dock hatch with FPV camera, plug and play for FPV flying.

- Large battery bay for extended flight time.

- 3 sets of different decals, make your scheme different from others.

- Built-in CF strip inside fuselage for extra enhancement.

- Built-in CF rod in the ailerons will give precision and sharp action to your inputs.

- Dedicated equipment bay for Eachine Safe-Flight Control with GPS.

- Optimized air-cooling design will keep your gear safe from overheating.

KIT Includes:

Eachine Razor glider KIT with all hardware.

PNP Includes:

Eachine Razor glider PNP with pre-installed motor, esc, servos, propeller, hardware.

FPV Includes:

Eachine Razor glider FPV with pre-installed motor, esc, servos, propeller, hardware, Eachine AIO 400mw Camera with Vtx.
Posted by Old_Pilot | Yesterday @ 06:16 AM | 3,038 Views
Finally got this one sorted electronically..gonna try to maiden her this if successful
Posted by SHK1ECG | Yesterday @ 04:17 AM | 3,226 Views
This blog will describe the build of an own design electric powered Vickers Viscount - the world's first turboprop airliner. This will be my fifth OD model, earlier ones being a Scottish Aviation Twin Pioneer, Armstrong Whitworth Argosy, Piaggio 136 amphibian and most recently a Beechcraft King Air B200. Build logs are on this Group for the Piaggio and the King Air.

Specification for the model are:

Scale 1:12.6
Winspan 2266 mm (7 ft 5in)
Target Flying Weight less than 7 Kg
Fuselage Length 2070 mm (6ft 9 in)
Tailplane Span 850 mm (2 ft 10in)
Fuselage Diameter 262 mm (10 5/16 in)
Height (ground to top of fin) 653 mm
Nacelles - removable to fit flight batteries. Each will contain a 3S or 4S 2200 lipo, ESC, motor and safety link.
Motors - four brushless outrunners to produce at least 260W per motor for 80W/Lb . Ideally 4-blade propellers with squared-off tips.
Radio - 9 Channel Multiplex M-Link
Fowler flaps
OD retracts
Lighting system
3-piece removable wing
2-piece removable tailplane
auto connection of wiring and controls on assembly
British Airways colour scheme

Thanks go to :

Alexander B's thread containing research for a larger Viscount model. This has been dormant for several years and as far as I am aware has fallen prey to other commitments.

The Vickers Viscount Network run by Viscount enthusiasts with a large archive of material

Nick Stroud for his excellent book 'The Vickers Viscount' and published by Frontline Books.

At the present time, draft fuselage drawings are nearing completion, draft nacelle drawings are completed, as are the OD front retracts. Main retracts are still at the head scratching stage. The main build effort is expected to begin in the autumn and extend into the spring of next year.

Come along for the ride, and feel free to chip in with your advice or queries along the way.
Posted by Garden Gnome | Yesterday @ 03:50 AM | 3,258 Views
Hello I have a blade 70s and I'm finding it hard to bind it to a T8SG PLUS v3 carbon.does anybody now what I'm doing wrong?
Posted by Catherine Chen | Yesterday @ 02:48 AM | 3,355 Views
Hello Everyone,

Wish you have a nice day!

We have QS8-S , QS8L, and QS8U Antispark connector want to share with you.

Please check Picture.

Best Regards
Posted by jmxp69 | Aug 06, 2020 @ 10:15 PM | 3,800 Views
Ever wish you had more than one momentary switch on your OpenTx radio? I do--every time I fly. This video shows how to use software to get three different functions on your momentary switch:

3 Functions 1 Switch: OpenTx Edge/Sticky Logical Switches Explained - OpenTx Tutorial for Beginners (16 min 58 sec)

Posted by cuavlindy | Aug 06, 2020 @ 08:07 PM | 3,907 Views
CUAV Pixhack V3X Flight Controller PIX Open Source for FPV Drone Quadcopter Helicopter RC parts whole sale free shipping