Comments (0)
Add Comment
-
Views: 287
-
Views: 297
All-Stock Internals. Planning to upgrade to an Eflite BL180 3600KV Motor and Eflite 120mm X 70mm Try-Blade Prop. Turnigy Nano-Tech 2S 300mAh 35C (16 grams) situated very aft (just a half inch in front of the UMX AS3X RX Board). -
Views: 296
A channel was carefully cut on the underside of the main wing with an XActo knife and an 8β .034β x .121β flat carbon fiber spar has been inserted for rigidity. -
Views: 292
All of the old carbon fiber connection wire bits have been sanded and painted over to match the scheme. Old connections to the interplane struts and fuselage joiner have been covered with their original plastics which I sanded so it looks stock. -
Views: 312
I could have flown another minute, but I ran out of maneuvers in my mind at the time that I could throw at it. -
Views: 289
-
Views: 317
One of the photo inspirations that led me to create the UMX Waco Golden Age Fantasy Racer.
-
Views: 309
-
Views: 377
Lemon RX DSMX 7-CH Diversity Stabilizer / Receiver mounted with Eflite Universal Light Controller plugged in to the Aux Port. -
Views: 384
Castle Creations Talon 15-Amp ESC with 8-Amp (Peak) BEC - Needed a higher-rated BEC for everything I'm running in this model. -
Views: 396
Dual Rudder Setup - Installed (2) ICE 5-Gram Servos and had the Dual Rudder's "melt-cut" with a soldering iron for a clean cut uniform appearance. -
Views: 374
Rudder Deflection. -
Views: 364
Internal Layout. -
Views: 382
Internal Layout (pt. 2). -
Views: 350
Added Rear Carbon Fiber Bracing to stiffen the rear fuselage from flexing due to the addition of Dual Rudders.