Comments (0)
Add Comment
Sticky:
RVOSD Gen.5 - Vibrations
-
Views: 248
I have bought some R/C Protective Foam Rubber, to prevent vibrations -
Views: 249
I have bought some R/C Protective Foam Rubber, to prevent vibrations -
Views: 357
I cut 4 pieces of rubber, and added double sided tape to stick it to the plane and the RVOSD -
Views: 408
Inside my Skywalker, with the RVOSD placed on the 4 pieces of foam. -
Views: 258
The GPS-cable was not long enough for me, so I cut away most of the cable, and used some soft servo-wires to get more length. -
Views: 297
The GPS-cable was not long enough for me, so I cut away most of the cable, and used some soft servo-wires to get more length.
-
Views: 364
The inside of my Futaba T7C and the 2.4Ghz RF module in the center. Notice that I have cut the 3 wires (red,brown,black). You ONLY have to cut the brown wire, if you want to turn off transmitting on 2.4Ghz ! -
Views: 316
The blue wires, is what you have to look for, if you want to find the right place to connect your LRS - showed with test in red. The green text is about the 2.4Ghz module. -
Views: 291
The backside of the 2.4Ghz module. This is where I did solder the 3 wires from the Scherrer LRS Tx. -
Views: 282
Black = GND, Red = Power, White = PPM -
Views: 281
Black = GND, Red = Power, White = PPM
-
Views: 351
-
Views: 252
-
Views: 201
-
Views: 201
-
Views: 200
-
Views: 191
Two pieces of aluminum, bend and put together with two plastic bolts -
Views: 198
-
Views: 205
This is a soft material (don't know the english word) that I have cut and used between the two plates of plywood. It is soft, and I hope it take most of the vibrations between the camera and motor.