Comments (0)
Add Comment
-
Views: 196
Front perspective. -
Views: 197
Rear perspective. -
Views: 178
Wireframe. -
Views: 235
DRAFT Fuselage plan / skin, with tiled print boundaries shown by dashed lines. SINCE SUPERCEEDED - see below. Only need two nacelle objects, but both outboard and inboard skins shown here. -
Views: 215
DRAFT Wing plan / skin, with tiled print boundaries shown by dashed lines. SINCE SUPERCEEDED - see below. Only need single stab and wing object, but skin is shown for both top and bottom. Also only need a single center fuselage object, but right side fin
-
Views: 187
Mike with his new Mini Apprentice -
Views: 178
A 3D printed motor mount was printed to replace the stock mount that broke. Brass tube spacers were added to correct side thrust. -
Views: 176
ESC wires were routed and secured with the new ESC location for more cooling air. -
Views: 177
The cowl had to be trimmed for the side thrust. -
Views: 186
1/8 brass tube bearing supports music wire bent 90 degrees. It is sandwiched between the rudder horn plate. -
Views: 165
Wire axle before getting bent -
Views: 161
APC 9/6E prop pulls 13 amps on the 18 amp ESC. The spinner had to be trimmed to fit. -
Views: 171
The belly exhaust port reveals the stock ESC. It was programmed for the hard brake to improve power off gliding.