Comments (0)
Add Comment
-
Views: 1016
The new molded GF wing joint with root rib stuck in it. The front end of the joint is to be glued to the backside of the spars shear web. -
Views: 785
The root rib extends into the aft potrion of the pod. Together with a screw at the LE it will hold the pod in place. -
Views: 801
-
Views: 873
-
Views: 776
-
Views: 790
-
Views: 691
-
Views: 828
-
Views: 978
Easy CG machine: two screwdrivers Now that is balance :D -
Views: 664
adhesive paper tape with the c/4 line and markings for 40% and 45% of the half span -
Views: 605
Same thing on the other side Note that the center of lift of a wing half for elliptical lift distribution is at about 42.'something'% =) -
Views: 804
-
Views: 729
-
Views: 835
-
Views: 895
The cut servo bays -
Views: 1035
D60 awaiting the stupid simple DIY RDS treatment -
Views: 1118
Paul doing the necessary epoxy surgery -
Views: 931
Et voila! -
Views: 1246
That's how the will go in there -
Views: 834
Two GF strips -
Views: 864
Steel wire as spacers -
Views: 834
Ready to inject the thickened resin
-
Views: 573
-
Views: 456
That's how the connector fits in the wing half. -
Views: 457
Wingspan is 1.2 metres -
Views: 426
The wing connector made from plywood will be used to epoxy the wing halfs together, it has anhedral of 3 degrees on each side -
Views: 592
The front of the connector will be glued just against the glas fibre shear web of the spar. While on this pic only the spar caps made of carbon rods are clear to see, I can assure you, the shear web is already there, aswell.