Rc Rod's blog View Details
Posted by Rc Rod | Oct 09, 2014 @ 05:12 AM | 2,521 Views
This is my 60% F22 for indoors, not shown but best to do before step 9 is to glue a carbon fiber spar to the bottom from wing tip to wing tip, just in front of the motor mount....Continue Reading
Posted by Rc Rod | Jul 08, 2014 @ 05:51 AM | 3,526 Views
Just a few pictures of my CNC machines. The Shapeoko 2 was purchased as a hardware kit from Inventables.com This is a very reasonably priced learning experience and I was able to cut my 1/4" G10 plates for my Ox on this.

The larger machine is capable of cutting 24.5 x 48.5 inches, the plans were from Openbuilds.com.

I'm running GRBL on both on an Arduino clone.

The JET dust collector in the background provides enough vacuum for the vacuum table, dust collection on the OX and dust collection on the Shapoko to all operate at the same time and will run all day without even getting warm.