FWAL's blog View Details
Archive for November, 2013
Posted by FWAL | Nov 16, 2013 @ 02:19 PM | 6,423 Views
Planking complete, pleased with the results. The transom is 90mm wide but looks a lot more in these photo's.
Posted by FWAL | Nov 11, 2013 @ 05:57 AM | 3,882 Views
Wiz will be the third IOM which will be constructed on 6mm thick foam board shadows. Foam board is readily available from hobby stores and is cheaper and easier to cut than say 1/8 ply. The slightest of draw backs is that the pins don't always produce a good hold. However, I have found that inserting the pins at an angle ensuring the pin projects through the paper surface of the board definitely increases it's holding capabilities.
To ensure the tightest of gaps between each balsa strip I rub over each edge with a small sanding block and 120 grit paper. The first edge which will be the open edge is sanded at 90 degrees, then I turn the strip over and sand the edge that will be glued at a slight chamfer. The angle of the chamfer normally increases towards the bow and stern to ensure a good gap free joint.
I have also found out that using the glue sparsely is the best way to reduce sanding and also vastly reduces the grab time. If you think about it you don't need a lot of glue to adhere 1/8 or 3mm thick strips of balsa together. Trust me sanding large globules of glue run off from inside a hull is a thankless chore.
Over time the hull slowly evolves. With this particular IOM I'm restricting myself to two strips on each side before leaving it alone for a couple of hours for the glue to cure. Whilst this is happening I add a couple of rubber bands and perhaps temporary wedges just keep everything nice and snug.
Posted by FWAL | Nov 08, 2013 @ 11:49 AM | 6,764 Views
Wiz - someone who is dazzlingly skilled in any field
or
Wiz- or Wizer is street slang for the drug Speed

My Wiz IOM is a combination of the two