kiwi_craig's blog View Details
Archive for November, 2017
Posted by kiwi_craig | Nov 06, 2017 @ 11:39 PM | 12,351 Views
As some will know there was a range of "issues" with the 2 in 1 esc on the blade 200 SRX tail motors, from my delving into this I have generally found the issue was more related to the wiring plugs, especially the slim line plugs in the tail rear section and people fitting the tail blade on backwards = instant motor over heat..

Others have added a standalone esc which I have done with success but have looked to go one step further and go dual stand alone esc's on brushless heli etc for ultimate tenability especially once the gutless main motor is ditched for some more respectable power wise ! 0n both the 200 SRX and the 230 S.

Builds in progress are:

Conversion of Blade 200srx with single 2 in 1 esc to initially a separate tail esc and then two aftermarket esc’s with replacement higher spec main motor (performance build).

Conversion of the blade 230 S to two aftermarket ESC’s with upgrade higher spec main motor.

200 SRX tail upgrades
Initial findings on my two blade 200 SRX’s – additional tail ESC, both are running three bladed heads, one with a stock main motor, the second with an up spec 210 watt - 4100kv motor (hobbyking EH200).

I have trialled two ESC units on the tails, DYS SN10A and DYS SN20A.

The 10 amp ESC is marginal and has resulted in motor overheating at times and are not recommended.
The 20 amp esc is performing fine and appears to be well suited to this application.

Next stage is to change the main esc out...Continue Reading