Archive for November, 2013
Was recently approached by Goldguy with the opportunity to add the Nutball to manufacturing repertoire. So after several test cuts and experiments for packaging here it is.
This entry will also act as a build guide for those who need it.
Web page to order kits is https://www.kenscadmodels.com/produc...y-frank-weaver
Ken
...Continue Reading
This entry will also act as a build guide for those who need it.
Web page to order kits is https://www.kenscadmodels.com/produc...y-frank-weaver
Ken
...Continue Reading
-
Views: 445
Overview of complete kit. Kits will also include pushrod keepers as well when they arrive, but I am not advertising them as part of the kit at this point. -
Views: 375
Main wing sheet with pushrods with pre bent Z bend and laser cut plywood parts sheet. -
Views: 381
Sheet 2 -
Views: 386
Square holes control the angle for a hobby knife to be run along a straight edge to bevel the control surfaces in one easy move. -
Views: 362
Note the pocket milling on the wheel hubs. That's right, this kit includes its own wheels. Plywood hubs fit into the pockets for secure attachment. -
Views: 345
Two .032" music wire pushrods with Z bend and one 12" piece of .047" music wire for the landing gear are supplied. -
Views: 383
Close up of 1/16" plywood parts reveals a firewall mount that will accommodate 10g, 16g, and Suppo style 1504, and 1510 motors. -
Views: 415
All parts released from the carrier sheet.
Comments (14)
Add Comment
