Comments (0)
Add Comment
-
Views: 294
After removing the lead from under the elevator, and the pushrods from the plane it was time to find the mounting locations. The plane had holes that were available for mounting.. I opened the hole then built a mount for the rudder servo on the top of th -
Views: 253
Then again opening the pre-existing holes on the side i made servo boxes on both sides for the elevator servos.. -
Views: 274
Finished product. Needs some yellow trim but all covered new push rods built... hope it helps.
-
Views: 142
The triangle block on the back of the firewall.. This pic was before I re-glued everything -
Views: 114
Another behind the first former. -
Views: 129
Motor box all re-glued. -
Views: 113
Building the landing gear. -
Views: 137
Nice strong wheel pants, with the blind nut already attached. -
Views: 126
Axle built -
Views: 127
and mounted. -
Views: 132
Trick for thread locker.. I use some small cut outs from the box to dip the bolt in.
-
Views: 189
Double Boxed for shipping. This is the inner box with pics :) -
Views: 136
Open the box to a full sheet graphics and a amazing manual. -
Views: 147
Wings, Elevator and Rudder all individually rapped. -
Views: 125
Parts box, with the carbon wing tube, inner and outer sfg's and parts bag with extra covering. -
Views: 128
All the parts laid out -
Views: 118
Carbon control horns and ball link hardware. -
Views: 134
Spinner included -
Views: 139
Wing tube and rubber coated washers for all bolts.. never seen an electric with this from the factory. It's standard for gas/glow planes.