In my previous post I mentioned I had the Eachine bound to my Turnigy 9XR Pro VIA a multi protocol module ...
https://goo.gl/cJvDpd Multi protocol Module ...
FYI , this module only does ( NRF24L01 )
https://goo.gl/R6ALz5 Eachine H8 mini ...
These are the instructions for binding ..
When you turn on the Tx hold the sticks in the following position ( on start - not after )
Rudder right + Aileron left = EAchine H8 mini 3D
Elevator up + Aileron right = EAchine H8(C) mini
Will the real Eachine stand up please !
These were the instructions , but for the Taranis transmitter .
For the 9XR Pro I found the following worked
Transmitter is mode 2 Left stick is Throttle / Rudder
Throttle Down / Rudder left ( bottom left corner )
Right stick = top right corner
Once the (?) model is bound , you should not need to repeat the process as the protocol ( model ) will be remembered next time you want to fly .
Like I said , the instructions are for the Taranis , so if you plug the module into any other Tx , you will need to explore for a bind .
Eachine H8 mini ...
I still haven't tried the factory remote .
The H8 bound to my 9XR pro shows great promise for a really good flying mini quad ( or is it micro ? )
It handles a breeze relatively well for it's small size
The H8 lacks power / or is a little heavy
Very strong , takes bumps well
Might be stunt able .. ( Very nimble )
For the price - seriously ! ( A lot of people will spend $
...Continue Reading