jackheli's blog View Details
Posted by jackheli | Dec 16, 2018 @ 12:13 PM | 3,552 Views
I can 3D Print a new back cover for the 9XE with all the bell and whistles of the original, plus a removal module bay. It also has a slot for a JST connector, in case you are using a 3 Cell Lipo.

Can be made in any color....Continue Reading
Posted by jackheli | May 03, 2013 @ 09:32 AM | 5,393 Views
I programmed this small microcontroller to perform the spool up and autorotation recovery for ESCs that don't have this feature built in.

If you are interested and into breadboarding I can provide you with the firmware. Send me a PM

DISCLAIMER: I make no assurances that it will work for you, that it will suit your needs or that it will perform the way it is intended to perform. This is a homemade prototype and you use it at your own risk.

RC Helicopter MCU Controlled Slow Spool for ESC (2 min 27 sec)

Calibration for RC Helicopter MCU Controlled Slow Spool for ESC (4 min 40 sec)
...Continue Reading