The "Tern" 2.0 Wing... A weakness of mine, the Flying wing. The last wing I had just did not perform like I wanted it to soooo... I have been looking for a replacement for awhile. I found the plans for this one on the Flite Test forum Articles page and I liked the design. The foam is stripped of it's paper and one side of the foam sheet is covered with 2 inch clear packing tape then the wing panels are cut out. A doubled foam spar and partial foam ribs form the airfoil. I covered it with vinyl sheeting leftover from work. I hope to have it up and flying soon... Mudman1959
http://flitetest.com/articles/flying...lapse-tern-2-0