Do this at your own risk

How to set up the V922 + HT8 module with a Flysky FS-T6 TX (big thanks to FyreSG for his assistance with curves and expo)

HT8 module - set to Futaba
The FS-T6 uses a 4 pin PS/2 style connector. This doesn't come with the HT8 so I purchased a 10-in-1 USB flight sim from Banggood - it comes with the required cables and also allows you to use the TX on fight sims.

I tested the DC socket on the TX - no voltage. You can't use it to power the HT8 so use it's internal Lipo (V3 HT8)

Set up the TX:
Some assumptions - you know how to add a model to the TX

1. Hold down the scroll button to enter Function menu
2. Enter System and create a new Model and enter a name.
3. In "Type Select" chose Helicopter Swash 120
4. Click OK to leave the menu
5. Hit Cancel to go back to the main menu

1.Select System menu
2. Reverse menu - Reverse channels 3 & 4
3. Dual rate / Expo
Normal
Ch1,2,4
Rate 65%
Expo -20

Sport
Ch1 & 2
Rate 100
Expo -20

4. Throttle curve
Normal
L 0%
1 40%
2 65%
3 85%
H 100%

Idle Up
L 100%
1 85%
2 65%
3 85%
H 100%

5. Pitch curve
Normal
L 40%
1 45%
2 50%
3 75%
H 100%

Idle Up
L 0%
1 25%
2 50%
3 75%
H 100%

6. Swash AFR
Swash Type 120
Aileron 40
Elevator 40
Pitch 50

7. Throttle Hold
Hold On
Value 0%


As always you can adjust the curves to suit yourself along with the AEP figures. You can also assign which switches you want for IU / TH.

I've just flown 2 batteries thru my V922 - hovering nicely and less sensitive than before. I may adjust a little more to reduce sensitivity further but right now it's fine for my uses.