sloped soarer's blog View Details
Posted by sloped soarer | Jul 29, 2013 @ 03:38 AM | 27,034 Views
Hello and welcome to My Blog.

Inspired by midelic on RCGroups, I decided to write My own Arduino sketch for a Flysky compatible Receiver.

This sketch will run on a 8 or 16 MHz 328 chip. Run the chip at 3.3 Volt.
It has various binding options, failsafe, ppm stream and 8 servo outputs. My first attempt connected to an old V911 Heli pcb. My second attempt connected to a HK 3 channel Rx with the original micro controller removed.
Both versions use the full 16 hopping frequencies defined in the protocol.

If you want some pix then i will post them up here.

Enjoy !.

Legal Disclaimer.
I will not be held responsible for any accidents / incidents in relation to the use of this code.