nick l's blog View Details
Posted by nick l | Jan 07, 2021 @ 01:37 PM | 5,167 Views
Saving the balsa colored stuff for later, I notice a post suggesting a simple mix for making a sanding sealer work around
with a 50-50 white glue and water mixture.

The sample part coated dried to a pretty smmoooth a bit harder surface finish, I like it.
I suspect regard for heat when using film covering should be considered, perhaps it could be an issue, perhaps not.

Thanks for the tip!
Posted by nick l | Jan 04, 2021 @ 04:44 PM | 5,820 Views
HK film sample for current project

I have used it in the past and noticed a slight pull @ the edges if its over heated near it's perimeter's, I like it but, I prefer Monokote.

Its all about what I have on hand for now but I think I have been saved by the beautiful examples that abound built by U All. ...Continue Reading