-
Views: 340
Not a direct drop in replacement but might work with some hacking away the case. -
Views: 312
Notice posts for case screws, flanges around these need to be filled or cut down to clear the pill bottle enclosure. -
Views: 363
Pill bottle bottom cut at a taper with speaker snug inside. A hole is drilled on the bottom to allow access for the wire. -
Views: 333
Using a step drill (from my Vans RV10 build days) I opened the front of the case. Removed the FrSky label above the speaker grill. Pre-drilled a starter hole then went very slow, step by step to the final size. Watch for loose pieces of plastic falling i -
Views: 443
-
Views: 341
-
Views: 369
Finished hole. -
Views: 342
Dry fit of the speaker chamber. Take your time here to make sure it seats properly. Check for clearance where the chamber bottom sets against the RF board when closed up. Make sure you have some clearance.
Comments (8)
Add Comment