Archive for April, 2018
-
Views: 229
Full metal heavy duty latch. -
Views: 236
Glued plywood piece and rounded to fit inside fuselage. -
Views: 246
Screws for added security. -
Views: 253
Slot for the latch pin done with a hobby knife and finished with soldering iron tip (to seal the covering). -
Views: 252
Latch glued with thick CA. I filled around the block with regular CA and hit it with CA kicker. -
Views: 267
Added lite ply sheet inside canopy to spread the load. -
Views: 233
Glued a plywood block in the position where the hole will be drilled. -
Views: 231
Using a marker I painted the tip of the pin.
Comments (0)
Add Comment