Comments (0)
Add Comment
-
Views: 348
Saito FA-115 is 18.9cc & can spin up to 16x6 prop according to HH website -
Views: 334
view from rear -
Views: 317
1.25 inch piston :o -
Views: 333
there's a Crankpin in there somewhere :P -
Views: 328
closer look at Main Bearing -
Views: 330
-
Views: 338
Valves. Left is exhaust -
Views: 321
intake valve with o-ring. I believe it is Viton
-
Views: 308
Spektrum SPM4648 beside Saito FA-72 case with new bearings and original crankshaft replaced -
Views: 301
Prop nut is on my FA-91S. Otherwise it's ready to run -
Views: 277
Rear view, ready to run -
Views: 291
Piston shows usage -
Views: 313
Head -
Views: 286
Cam case with Cam. Leave the Left Tappet (right one in this pic) out for timing the cam. Once timed, replace it -
Views: 281
Didn't clean the carb, it looks fine. I have a rebuild kit if needed -
Views: 290
Valve covers show wear but look good enough for this build. This engine is more a flyer than a show piece