santanig5's blog View Details
Archive for January, 2015
Posted by santanig5 | Jan 29, 2015 @ 10:13 PM | 7,324 Views
Hi all,
Well she is done, she may not look like much, but she is my first foam build.
I purchased the Airfield 1400mm P40 air frame at our club swap meet.
I don't know if it was a kit never started or an ARF stripped, but it had only 3 servos (Ailerons and tail wheel) and two broken retracts.
To my surprise, Nitroplanes no longer carries parts for these. I found that MotionRC carries the FMS version (they said Airfield copied FMS) and that the parts should work.
So I ordered the prop, spinner, motor, ESC, UBEC (never heard off these before), Elevator and Rudder servos AND new retracts. And of corse an EFLR3100113 SAFE receiver. I used a wooden dowel with duct tape for a swing spar and packing tape to hold them securely to the fuselage as there was a large gap with just a single screw holding the wings.
I haven't flown her yet, but when I do I will report back.

Parts List:
2 x Admiral 2500mAh 4S 14.8V 30C LiPo Battery
1 x 1400mm FMS P40 Camo Spinner
1 x 1400mm FMS P40 Camo Retracts with Main Gear
1 x FMS 9g Servo
1 x FMS 17g Digital Metal Gear Servo
2 x Charge Lead Banana Plugs to T-Connector
1 x ZTW Air ESC Programming Card for FMS and RocHobby ESCs
1 x FMS 3648-600Kv Motor
1 x ParkZone Clevis Set (4 Pack)
1 x E-flite Apprentice S 15e Cowl
1 x E-flite Apprentice S 15e Spinner
1 x E-flite Apprentice S 15e Rubber Bands (8)
1 x ZTW 10A BEC / UBEC
1 x FMS 60A ESC
1 x 1400mm FMS P40 Camo Propeller
1 x 1400mm FMS P40 Camo Motor Mount
1 x 1400mm FMS P40 Camo Motor Shaft
1 x 600mm (24") Servo Extension Cable
4 x 300mm (12") Servo Extension Cable
4 x 200mm (8") Servo Y Extension Cable

Thanks to all of you for your advice and guidance, I could not have done it without you!