Added 4s hyperion packs, 12T pinion, and v3 head block and grips. Swapped the ice lite 50 in from the 500. Tossed on rotortech 350s. Spooled up and noticed some nasty vibrations, discovered that the feathering shaft bolts were loose. Do-over in a few hours after the loctite can cure some more.

I stretched the 450 with the boom, belt, and woodies from an outrage g5. The blade tracking still needs to be dialed in; otherwise, it flew fine. Autorotations were floaty, but the roll rate was lower than it used to be. The 450m bogged a bit on 14T, and the cc35 got hot. Next up:

* 4s+12T
* ice lite 50
* rotortech 350mm CF blades
* v3 head block and grips
* pro tail blades