JureZ's blog View Details
Archive for October, 2014
Posted by JureZ | Oct 28, 2014 @ 12:17 PM | 10,671 Views
My implementation of the Vanessa CG machine.

found the attached construction document (pdf file) and decided I needed to build one.

I'll have to look up the thread where I found it in RCG ...click here for thread

Some pictures pasted below , to show its actual use with the mini Funtana.
Posted by JureZ | Oct 27, 2014 @ 11:57 AM | 10,058 Views
Hobbico Superstar EP


bought this airframe at a swap meet, for next to nothing.
Added new motor, ESC , receiver and servos.
After some time, landing gear , spinner , and a cowl made from a plastic bottle .

Finally , hired Felix as the pilot

Note: The Hobbico Superstar EP manual is attached to this post
Posted by JureZ | Oct 27, 2014 @ 10:21 AM | 10,608 Views
mounted the Mobius HD camera on a hard hat, as it is stronger and provides a more solid platform than other types of hats.

Went crazy with the stickers...


.
Posted by JureZ | Oct 27, 2014 @ 07:47 AM | 9,261 Views
Magnetic prop balancer

built using a finger prop balancer ( bought from Uncle George, a fellow RCG member ), and two magnets scavenged from Hard Disk Drives, previously part of the voice coil head actuator.

If interested , I have a few sets of magnets to give away for free,

click here to see a short video of the prop balancer in action
'
Posted by JureZ | Oct 26, 2014 @ 11:08 PM | 9,840 Views
Here are some pictures of the Mini Funtana I've got as a gift from Mike L (RCG member).

The plane needed just a little TLC to get in flying condition, and here it is waiting for the new maiden flight.

With the spare wing also provided by Mike , I would like to add a center section and use it as an aileron wing for the SuperStar EP.
This new section extends the wing span to 40"....Continue Reading
Posted by JureZ | Oct 26, 2014 @ 08:38 PM | 7,440 Views
My Static Thrust test fixture .


The Tachometer function is built around a Velleman infrared beam interruption kit , model MK120 ,
bought at Fry's for $8 , ( link to the MK120 kit ) , with some minor circuit modifications.

The digital scale is a Centech 1000g full scale unit bought at Harbor Freight.

The Fluke multimeter is set to the frequency , [Hertz] , measurement mode.

N [RPM] = 30 * Frequency [Hz] , in the case of a two blade prop.

To measure the battery current , I use a Simpson RMS Current Clamp meter

A servo tester is used to drive the ESC control input (bought from ED3, a fellow member of RCG).

.
Posted by JureZ | Oct 25, 2014 @ 12:39 AM | 5,686 Views
just to get my blog started, here is a link to my flickr RC album: Jure Z : my flickr album

also, videos on facebook : https://www.facebook.com/sifon.templar/videos

click on the links above to see pictures and movies of my airplanes and equipment.

The last addition, videos on YouTube:
https://www.youtube.com/channel/UC_5...DrI2oswi56rb-w