AL Porter's blog View Details
Posted by AL Porter | Jun 02, 2019 @ 10:06 PM | 899 Views
Posted by AL Porter | Jun 02, 2019 @ 10:03 PM | 846 Views
Posted by AL Porter | Dec 17, 2018 @ 08:55 AM | 5,332 Views
Combat Day at Topsail Electric Flyers Association
Posted by AL Porter | Dec 17, 2018 @ 08:48 AM | 2,296 Views
NC Inlets (13 min 26 sec)

Posted by AL Porter | Dec 17, 2018 @ 08:42 AM | 2,302 Views
Combat Flt 2 (3 min 44 sec)

Posted by AL Porter | Mar 19, 2018 @ 07:26 AM | 3,125 Views
I decided to build the Ryan STA Special that has been in a box for 48 years....Continue Reading
Posted by AL Porter | Jan 30, 2016 @ 08:01 PM | 5,978 Views
Posted by AL Porter | Jan 08, 2016 @ 05:30 PM | 4,926 Views
I build and installed Naza controllors on Multicopters. I have had individuals call me after they install the NAZA controllor and the motors well not start after using the Assistant Software Installation. The most common problem for this is in the command Sticks Calibration in the RC tab under Basic the Command Sticks are not moving in the right direction. If you are using DJI esc opto's and DJI motors check this first "THE ELEVATOR STICK MOVEMENT" if you move the stick to the low position the slider should move left and to the up position the slider should move right!!!!!!! IF NOT THE MOTORS WILL NOT START. DJI opto ESCs "Do not need to be calibrated with your throttle stick!"
IF YOU ARE USING OTHER THAN DJI ESC'S YOU MUST CALIBRATE THE TRANSMITTER THROTTLE STICK FOR EACH ESC INDIVIDUALLY PRIOR TO CONNECTING TO THE NAZA CONTROLLER.
REFER TO THE FIGURE BELOW
Posted by AL Porter | Dec 09, 2015 @ 08:49 AM | 4,542 Views
Kong Copter Leaf Blower (5 min 16 sec)

Posted by AL Porter | Sep 15, 2015 @ 12:05 PM | 5,843 Views
Materials:
1. 2 carbon arrow shafts from Dicks sporting Goods
2. Mystery 30A Brushless ESC with BEC
3. T-Motor MS2212-13 KV: 980
4. 2 HobbyKing HK 1514BB servos
5. 1 GF 1045 Prop
6. Spectrum AR6200 Receiver or whatever
7. Turnigy 20-30c 2200 3C Lipo
8. 6 control rods servo linkage 65MM: HobbyKing: https://www.hobbyking.com/hobbyking/...dProduct=57534
9. 2 1/2 inch Pvc Coupling
10. 5 Min Epoxy
11. Aluminum stock 1"X 1/4" from...Continue Reading