Comments (0)
Add Comment
Sticky:
Links to my builds
-
Views: 718
Spektrum module in HP6DSM. One screw and it comes out. -
Views: 544
Remove screw to remove antenna. -
Views: 549
Antenna and module. -
Views: 468
Antenna disassembled. -
Views: 541
Desolder the antenna from the Turnigy module. -
Views: 481
Remove the screw to remove antenna from the 9x. -
Views: 441
The two antennas, 9x on the right. -
Views: 493
Drill out the base of the 9x antenna to accommodate the HP6DSM's antenna connector. A few wraps of tape are needed for a tight fit.
-
Views: 116
Cut tabs with utility knife. -
Views: 109
Glue the long ribs together. -
Views: 104
F4 and F5. glue these in first. -
Views: 115
Tack glue the F4 and F5 supports back in. These will provide support when sheeting the wing. They will be knocked out after sheeting. F6 glued in too. Note rubber band across top of F6 to hold it tight to the rib. -
Views: 91
Glue the rest of the formers in. Rubber band also across F7. -
Views: 121
Close up of the rubber bands. -
Views: 97
FR2 added. Tack glue end tab into F5 support. The end will be removed after sheeting. F6 and F7 tops held tight with rubber bands. -
Views: 95
FR3 added. Rubber bands hold the rib onto the end tabs.