R/C Blogs - RC Groups
Posted by MDheliMech | Today @ 12:50 AM | 102 Views
I have been gone for so long I forgot about being a member here. I am so horrible at focusing on all of my different hobbies. I have serious HAD (hobby attention deficit). I sort of lost sight of aircraft and got into model railroads. Then I got into making terrain for tabletop games. Recently I was telling an engineer that I work with about the EDF tri-copter I built. I was bummed out I didn’t have any pictures of it. Then I remembered that I had posted some on the internet somewhere. I searched for the Twins Multi Purpose Cargo Plane, and found my way right back here. Hoping to get back into the hobby.
Posted by Jack Crossfire | Today @ 12:40 AM | 101 Views
4 months after the last wheel failure, the same left front wheel broke off again.


& the right front tire continued to have wear problems. At least it got a good video before it died.

19 minutes at 7m18s per mile (2 min 40 sec)

Posted by xanuser | Yesterday @ 11:09 PM | 138 Views
Flex RC asecnet 2" frame
boldclash 1103b 8000kv. possibly from conformal/ needs replacement motor. front right motor stalls.
micro swift.
16mm stack. https://www.banggood.com/Super_S-F4-...r_warehouse=CN
akk nano. (from 3.3. firmware "sale")
Posted by old4570 | Yesterday @ 07:26 PM | 237 Views
My wing is here from FastTech dot com ...
I put it on the scales and got 46 grams ( for the foam components ) , that leaves me some 54 grams to play with to get to my goal of 100 grams RTF
Just waiting on the 2.5g servos now and some small ( 1.5mm ) screws
Posted by mlilasic | Yesterday @ 05:29 PM | 288 Views
Review (ip) of Eachine E010S PRO - 65mm 5.8G 40CH 800TVL Camera F3 Built-in OSD High Hold Mode RC Drone Quadcopter

This quad remained my on the Jaws. Too bad it cant go underwater

This cool design aldought brings great benefit for beginners because all electronic parts are well protected in canopy it makes life a little bit complicated (we are spoiled) to initially setup the quad because bind button for RX, CH/TX button and USB port are all hidden under canopy.
Good thing is that after initial setup there's no need to do that again because quad has OSD so most important BetaFlight settings are tunable via OSD.

I can reccomend this quad already to beginers because its great protection of el. components and antennas.

VTX antenna is hidden in shark tail ant RX antenna is laid horizontal "out of the box". When I opened the shark to adjust my CH/TX I put the RX antenna to upright. I believe it should be better that way.

I did a short hover and LOS test after setting in BF my modes and it flies great.
Flight video footage to come tomorrow so stay tuned.

  • Weight:

...Continue Reading
Posted by kydawg1 | Yesterday @ 04:15 PM | 287 Views
Posted by yosemitez | Yesterday @ 04:11 PM | 297 Views
crossfire micro, X220, 600mw vtx foxeer, 1300mh battery, eachine vtx antenna
ground station is immersion diversity with truerc canada X-AIR 5.8 and patch
still had great video and you see the readouts from the crossfire in the chart. battery is only limiting factor
Posted by Old_Pilot | Yesterday @ 03:33 PM | 369 Views
Nice CNC kit from Bob's CNC...expanded to cut 41"
Posted by Tom Hunt | Yesterday @ 02:22 PM | 346 Views
I was involved in the power selection for the HK Avios Grand Tundra when Stuart Warne was still at the helm. Now that Stephen Neill has taken over he graciously sent me one for my personal use after I beat up a prototype model Stuart sent me last year. The proto is still in good flying shape, but kinda dented and dinged. Originally just an "albino", Stephen sent me a set of decals for it. I also converted it to clear windows which I will show how that is done after the pre-orders have reached the modelers. but until then I would like to discuss the inflight data I will be collecting on the model.
Posted by Absaroka | Yesterday @ 02:18 PM | 337 Views
Put a Sk3 3542-1000 in the old Tundra. Here's the trial flight.
Old Beast with 4S (2 min 3 sec)

Posted by Thomas B. | Yesterday @ 12:58 PM | 365 Views
The Ekranoplan plan is now online as a free Modell-Aviator download.
Here isthe build log:
Posted by Reckless_fpv | Yesterday @ 10:31 AM | 424 Views
Posted by Jeffrey Ewing | Yesterday @ 09:46 AM | 446 Views
Check out my latest build. I'm working hard at trying to grow a channel dedicated to the drone racing community. Hope you guys like the new video, and as always please hit the like and subscribe.
P.S. If there's any vendors out there who would like to have me review a 6s lipo in my test flight video... let me know. Thanks, Jeff.
How to build a 6s racing done "Merica" (23 min 16 sec)

Posted by Calcifer | Yesterday @ 08:26 AM | 498 Views

CSI Spoof: Black Lights Expose Semen (0 min 50 sec)

Posted by archerfpv | Yesterday @ 06:39 AM | 547 Views
Batteries up, props down!

Finally got a GoPro Hero5 Session and have been playing with the iPhone apps lately. Just need to make some longer clips now. I've mainly been posting clips on my instagram www.instagram.com/archervr1
Here's a short 1 min clip I just posted on my YouTube, you can also see I'm flying a lot better than I was 7-8 months ago. Still using the 210 budget quad but in the process of building a floss 2 and a new freestyle rig using premium parts. Pics and vids to come on that one.

FPV Freestyle... on a budget (1 min 0 sec)

Posted by Tazkiller85 | Yesterday @ 05:19 AM | 602 Views
Yep Les Amis,
Selfie or not Selfie ... Voici un nouvel engin spécial selfie qui avait l'air prometteur sur le papier, le SG700, un appareil qui propose pas mal d'options sympas. Le positionnement optique fonctionne plutôt pas mal, pratique pour les prises de vue et selfie. Le maintien d'altitude par contre, est un peu aléatoire avec une légère brise alors qu'en indoor pas de soucis. La résolution d'image Photo/Vidéo reste moyenne malgré les 2M de pixels. Gros soucis par contre sur la reprise de stabilité après des accrobaties .En bref petit drone sympatique pour se faire la main grace à son assistance mais il ne faut pas trop lui en demander.

SG700 Selfie et positionnement optique Review Test Démo / De belles promesses ! (22 min 39 sec)

NOTATAZ : 14/20 Rapport qualité prix moyen !

Les + : Nombreuses Options de vols, Appli assez réussie, facile à piloter avec la radio, Positionnement Optique correct.
Les - : Perte de contrôle lors des Flips auto, résolution caméra moyenne et maintien d'altitude pas régulié.

Les produits présentés sont visibles ici (en cliquant sur ces liens vous soutenez ma chaîne) Merci à vous :
- SG700 (Ebay FR) : https://goo.gl/QoL1Ww
- SG700 (Ebay US) : https://goo.gl/47zYYV

Mon matériel :
- Caméra GIT2P (casquette) : https://goo.gl/auJNu2
- Camescope Endoer (Macro et Photos) : https://goo.gl/PA6WQX
- Caméra FIREFLY 8S : https://goo.gl/4TVS24
- Caméra DBPOWER 4K (écran tactile) : https://goo.gl/iqRRrv
- Micro...Continue Reading
Posted by goowellrc | Yesterday @ 02:12 AM | 689 Views
Dear hobbyist,

we are factory manufacture of the connectors and cables of the drones,right now we want to develop a new type connectors,we want to collect your suggestions. please speak out your mind.
Like Do you have any problems during the use of the XT60 or Deans connectors? and for the new connector, What performance do you want to improve most? we really need your guys help. looking forward to seeing your comments,thanks
Posted by alex111 | Yesterday @ 01:24 AM | 709 Views
My model boat room I think it’s a bit full haha
Posted by Jack Crossfire | Yesterday @ 01:16 AM | 722 Views
If the price is based on 100 passengers, with only 40 staterooms, they're planning on people traveling in family units with some of those families having kids young enough to sleep in the same room. The actual price per room is $500,000.

This is might have been Elon's parent's organisation, but it's definitely not the mane social organisation today. Lions still insist the mane customer will be confirmed bachelors looking for the ultimate retirement home.

Most families today from baby boomers to generation X to millenials still have a single male breadwinner earning most of the money & a "partner" earning pinch money.

What's advertised as $200,000 per person is really $500,000 a man has to produce for a room, whether traveling alone or with 2 family members. There might be a way to split it with a room mate, but that still hits $250,000. Suspect that's the mane way most of us will go, but since we wouldn't have to sleep at the same time, there wouldn't a real need for each person to have an entire room.
Posted by Bugkilla77 | Apr 24, 2018 @ 11:10 PM | 766 Views
I've got a bugs 3 I just put a New receive on an I can't quite get it right. EverytI me I think it's saldered right it losses power. Is there a way I can pin-point the problem with a tester are some other way to know where the problem is