legacy115833's blog View Details
Posted by legacy115833 | Apr 05, 2015 @ 03:27 PM | 11,845 Views
Posted by legacy115833 | Mar 21, 2015 @ 10:55 PM | 12,140 Views
Tuning session 3/21/15 (2 min 56 sec)

Posted by legacy115833 | Feb 28, 2015 @ 07:57 PM | 12,759 Views
Posted by legacy115833 | Feb 22, 2015 @ 08:05 PM | 13,515 Views
Posted by legacy115833 | Feb 16, 2015 @ 12:19 AM | 13,345 Views
Link to full build http://imgur.com/a/jIAsi


Posted by legacy115833 | Feb 07, 2015 @ 08:14 PM | 14,330 Views
Got to meet the guys behind the quad from Drone Kraft today. The bird was a beast and the guys were a blast to fly with. check them out at http://www.dronekraft.io/

heres a quick clip from my point of view today
Ferry Point Brooklyn NY Drone Kraft Meetup (2 min 55 sec)

Posted by legacy115833 | Dec 15, 2014 @ 02:41 PM | 12,462 Views
Blackout Hex vs. ZMR 250 (4 min 38 sec)

Posted by legacy115833 | Dec 10, 2014 @ 07:35 PM | 12,032 Views
Posted by legacy115833 | Dec 04, 2014 @ 10:23 AM | 12,108 Views
Blackout Vs Crapout (4 min 50 sec)

Posted by legacy115833 | Nov 23, 2014 @ 09:27 PM | 12,356 Views
Posted by legacy115833 | Nov 22, 2014 @ 03:12 PM | 12,245 Views
Posted by legacy115833 | Nov 13, 2014 @ 09:50 PM | 12,506 Views
So the maiden day for my Blackout H didn't go so well. It started off with my camera not working. Apparently my video filter fried and wasn't sending power to the camera. So I borrow a camera and wire and now I'm in the air. First flight pids were on stock settings no good. Second flight was ok but only ok. Third flight it started going down hill. Now I'm getting radio lockouts left and right. Turns out where the satellite was mounted wasn't working with being so close to the new esc. Well i still had some fun and its seems to be fixed now with a decent tune on it so hopefully next weekend is better. This is some of the better moments of the day.


Blydenburgh Park FPV (5 min 15 sec)

Posted by legacy115833 | Nov 02, 2014 @ 05:59 PM | 12,684 Views
starting fresh with tiger 12a esc and tiger 1806 2300kv got the first one on there 5 more to go


Posted by legacy115833 | Oct 26, 2014 @ 07:17 PM | 14,523 Views
Got most of the wiring and looming done today. Kiss 18a esc installed and wired up to a set of MN-2204 2300kv Tiger motors




Posted by legacy115833 | Jun 15, 2013 @ 11:17 PM | 12,953 Views
Just wrapped up the new 450 build . this heli is sweet. only bad thing i found was that the tail slider arms needed a little sanding to operate smoothly. other than that went together perfect. could use a shim or two on the main grips as well