Jim.Thompson's blog View Details
Archive for December, 2018
Posted by Jim.Thompson | Dec 25, 2018 @ 07:38 PM | 4,993 Views
This is my very first Arduino project.
Thanks to Hans Meijdam on this site for the design, guidance and assistance: http://www.modelbouwforum.nl/threads...-vario.199904/

The only problem I encountered along the way was Linux Mint permission problems. Once I got around them, all went according to the instructions.
I have encountered "Permission Denied" problems before in my otherwise excellent Linux Mint 17.3 operating system. Don't ask!.............

It is amazingly sensitive and sounds like a full size sailplane vario.
Posted by Jim.Thompson | Dec 10, 2018 @ 04:19 PM | 3,981 Views
The advantages of this method are:
1. Light and strong.
2. Ease of construction.
3. Quick and cheap. Foam for the ribs can often be found from recyclers.
4. Accuracy. All ribs cut together in the one set up. Cannot get them better aligned than that.

For my next constant chord wing using this method, I plan to construct the spar first. It will go something like this:

1. A foam core tapered in thickness will be hot wire cut. Dimensions will be the airfoil thickness minus the carbon caps, minus 1 mm for sanding/fairing balsa. Lets say, nominally 35 mm high and 8mm tapering to 4mm thick, (for example sake only).
2. This core will be faced in 1 mm Pauwlonia ( but could be balsa or basswood et. al.) with vertical grain orientation.
3. End grain of the timber is then sanded down to the foam.
4. Pre-made carbon spar caps are then added to the top and bottom of the assembly. These will be layed up using common uni-carbon/laminating epoxy which is cheap.
The thickness of these caps are tapered out to the tips.
5. The caps are glued on and the assembly wrapped with Dyneema, Kevlar, or other similar high strength braided line. Then all given a light application of thinned epoxy resin.
6. The "laser method" hot wire cut ribs are cut with a slot to take the spar. The building board might be in two parts, to enable separation of the two halves to allow the spar to be lowered into place, glue applied, then the two halves brought together.
7. The joiner boxes will be glued into the main spar and the assembly wrapped again.

I fully expect this assembly to be super light and super strong.

Video of a top cut:
Top cut left wing (1 min 35 sec)

Posted by Jim.Thompson | Dec 02, 2018 @ 03:37 PM | 4,768 Views
Link to the vimeo video here:
Silicone Hinge Demonstration (8 min 19 sec)