This is the first entry into my blog.
I am converting a Ultra Micro Mustang to a 2s brushless setup. My first photo shows the motor and board I will use. It is what was left from a UMX Beast. I bought it from one of the RC Group members.
The first thing I had to do was repair the motor because the blue wire broke off in the crash the did the Beast in. It was very tedious because the wires are so small. Got it done and put new shrink wrap on the wire and around the motor base to hold all wires in place.
I then plugged everything in got a 4 channel transmitter bound the receiver and tested the motor. It ran good and all servos worked.
Next step is to start conversion of the plane.