Comments (0)
Add Comment
-
Views: 447
Test fit -
Views: 435
Motor stick placement with mock up motor. -
Views: 395
Motor vectoring cable alignment -
Views: 382
Cable clearance and alignment for front mounted servo -
Views: 438
Motor stick henge and cable set-up check with mock up motor. -
Views: 377
Forward mounted vector servo -
Views: 387
Tight -
Views: 399
Close up
I guess Brad liked the colors of the Glow pwr Wizz so its a repeat.
They do stand out in the air and contraz well.
Its covered, hinged and servo'ed.
Need motor mount hard points, bottom fin, linkages and horns but it's a long weekend
They do stand out in the air and contraz well.
Its covered, hinged and servo'ed.
Need motor mount hard points, bottom fin, linkages and horns but it's a long weekend
Diamond Dust is next on the block.
Drive depends on how E Wizz works out
Drive depends on how E Wizz works out
-
Views: 534
Less the Glow Motor, this is typical of the end product. (Its actually the last one I built in FL) -
Views: 441
(Initial mock up) Mounting plate will be either Aluminum or Carbon Fiber. Oversized at this point, it will be thinned down once all mounting points are set as well as positioned flush with the mounting plate lead edge.
-
Views: 545
Compare adaptors and motor shafts on MEC GB. MR 28mm with MEC adaptor (blue), Neu 1107 and AstroFlight adaptor (Aluminum) -
Views: 411
Checking depth of GB and motor (actually could run this way) -
Views: 437
Another mounting option, motor plate would be notched and assembly set back from this position with prop shaft flush with front of the plate. -
Views: 454
Picture this set-up only inset back approx. 20-25mm -
Views: 414
As far as the mounting goes, its a blank canvas. Outrunner mounting with cut-a-way the most all the plate that ties the LE and Spars into the airframe, but that will be overcome it needed. -
Views: 421
Shaped and ready for flying surfaces and covering, as it sits, 6.2oz/177g
