dangerdan's blog View Details
Posted by dangerdan | May 23, 2020 @ 11:15 AM | 7,231 Views
I'm on OpenTX 2.3.7

This X10S is new with no programmed models. If I had one programmed, I might have stumbled across the correct option to see the Spectrum Analyzer.

To see the Spectrum Analyzer do the following :

Select a Model
Goto Model Setup
Scroll down to Internal RF
Change Mode to ISRM and Select Access or D16

Now click the SYSTEM button on the left side
Select TOOLS and look for Spectrum (INT) . If it's not there, then I have no idea
Click on Spectrum (INT)

Posted by dangerdan | May 10, 2015 @ 06:48 PM | 22,369 Views
Posted by dangerdan | May 10, 2015 @ 08:36 AM | 11,467 Views
Cut plywood 3 to 4.125"x 1.375"
Dry fit to plane and mark the dowel location making sure the marks are just above the rubber band knob.
Drill two .125" holes.

Cut plywood 1 to 5.5"x 2.625" and shape as shown.DONT DRILL HOLES YET.
Draw a line 1"x 5.5" from the bottom. This part fits in the wing.
Cut plywood 2 to 4.125"x 1".

Dry fit plywood 3 to plane.
Place plywood 1 in front of plywood 3.
The drawn line on plywood 1 should align with the top of plywood 3.
Remove both pieces making sure they dont move. If they move start over.
Drill plywood 1 using the existing holes in plywood 3. When done re-drill the holes to the proper dowel diameter.
Epoxy plywood 3 inplace and wait till cured.
Stick an AWL thru the predrilled holes making sure they go below the rod that holds the rubber band knobs.
You can use a drill bit to enlarge the holes to the correct size.
Cut dowels to length and dryfit thru plywood 3.
Place plywood 1 over dowels making sure the pencil line aligns with the top of plywood 3.
If all is ok, epoxy the dowels inplace using 30 min epoxy, then place plywood 1 on the dowels making sure that the drawn line on plywood 1 aligns with the top of plywood 3. Make sure these 2 DO NOTt stick together.

When cured, CA plywood 2 to plywood 1.
Cut an opening in wing to accept plywood 1 and plywood 2 making sure the opposite side of the wing is not cut through.
Do a...Continue Reading