30v2's blog View Details
Posted by 30v2 | Jun 09, 2013 @ 09:38 AM | 4,926 Views
The 1/2 Regal is based on the scaled down plans for the full size 40 inch wingspan Regal designed by myself and Kaos2 (my father). The original Regal flies extremely well, but is too large for the space that is most convenient for me to fly. With a 20 inch wingspan, the 1/2 Regal will hopefully bring all the performance of the original Regal to my backyard.

At this point I have printed the plans and prepared the parts. Dollar Tree foam is being used, which provides a nice 20 inch width that matches the wingspan. Cutting out all the parts took little more than half a sheet. With the parts cut out, I went ahead and "painted" the canopy, blue and red stripes on the wing and elevator (blue on top and red on the bottom), a blue stripe on the rudder, and "Regal" written on the wing and both fuselage halves. This was done with sharpies, a ruler, and a stencil. It should give a clean look that allows me to differentiate between top and bottom while flying.

I have also prepared the control surfaces by cutting a 45 degree angle on the leading edges. For best results I use a straight edge and angle an x-acto to create the 45 degree angle. With this method I take the foam from the bottom of each control surface (for aesthetic value), and then will use clear packing tape to create the hinge. More pictures of the hinging process will be posted later.

If it flys well I plan on posting the plans in the scratchbuilt foamies section. Unfortunately the electronics and foam safe ca are still en route, so until everything arrives there is little more I can do.

Update: I have replied to the original post with current progress. Check 'Comments' for more information on the build.

Link to original Regal thread: https://www.rcgroups.com/forums/showthread.php?t=712006
Link to the biplane version of the Regal: https://www.rcgroups.com/forums/showthread.php?t=787585

Pictures of the progress thus far:
Posted by 30v2 | Dec 20, 2007 @ 10:48 AM | 5,439 Views
Video of my Regal Bipe:

KF Regal Bipe Flight Demo (4 min 35 sec)

Posted by 30v2 | Dec 18, 2007 @ 12:57 AM | 4,693 Views
The video of my Regal flight:

30V2 Flys The KF Regal (3 min 44 sec)

Posted by 30v2 | Dec 12, 2007 @ 01:53 AM | 8,553 Views
My father (Kaos2) and I have decided to modify the design of our Regal into a biplane version. We are expecting that the Regal Bipe will have a lighter wing loading and faster roll rate than the original Regal. It will be especially interesting to see how well this plane handles slow flight and harrier with the two KFm wings. With both the E-flite Ultimate and the Infineon I have experienced a "wallowing" feel when flying slow, and I am hoping that this plane will not have that trait. Only time will tell whether our predictions are accurate, or if there will be any other performance changes that will occur.

I started building the Regal Bipe on Saturday (12.8.07), and am currently finishing up the build process. Along the way I have taken some pictures of the build, which has been very easy thus far. The pictures will be posted shortly along with some brief descriptions of what the picture is showing.