Archive for May, 2017
-
Views: 140
Completed door is flush with top of wing. Bungees are fore and aft and not criss crossed to allow door to hinge open and close. -
Views: 157
Door hinged open revealing Dremel'd out foam and rear end of 3300 3S stock battery pack. Door stops are CA'd to under the wing to provide for lateral keying against the fuse sidea and to limit the door to stay flush with surrounding wing area. -
Views: 171
The left and right doors are CA'd together and white Monocote/vinyl is used to cover Tyvek hinges and wing seam. A pull tape is used to pull up on the rear door to overcome the friction fit. No magnets or latch required. -
Views: 168
Completed battery floor angled down with green velcro hold down strap and white foam compression strips. ESC is moved to the side. -
Views: 148
Completed tray waiting to be screwed to cross braces. Plan dimensions in background. -
Views: 156
View from aft looking forward showing tunnel that accepts batteries to the forward end of lower battery compartment. -
Views: 157
Email me if you want a better copy. -
Views: 173
Small box cutter fully extended to just under the wing peg/tube. This is the ceiling of the foam battery compartment. A cross brace is wedged between fuse sides for the forward floor support.
Comments (1)
Add Comment